Dictator E8 Техническое руководство - Страница 11

Просмотреть онлайн или скачать pdf Техническое руководство для Системы управления Dictator E8. Dictator E8 19 страниц.

Tel. +49(0)821-24673-0 • Fax +49(0)821-24673-90 • E-mail [email protected] • 20200703

III. Adjustment / Programming - cont.

„P-3" Function of the Stop-switches 2 and 3 in alarm

This parameter offers the possibility to cancel the STOP-command during

an alarm closing.

Value 000:

STOP 2 and STOP 3 also active during an alarm closing

Value 001:

STOP 2 and STOP 3 without function during an alarm

„P-4" Blocking the door in the closed position

This parameter offers the possibility to block a door in the closed position

with an electromagnet incorporated in the door drive (special design!)

Value 000:

Blocking on

Value 001:

Blocking off

Ex works the parameter „P-4" is adjusted to 001, that means no blocking

in the closed position.

Note: The blocking force in case of a drive unit with power transmis-

sion by rope is about 50 kg and in case of a toothed belt about 80 kg.

„P-5" Automatic closing

The parameter 5 permits to activate or switch off the automatic closing

and to adjust the time after which the door closes automatically.

Value 000:

Automatic closing Off

Value 001 - 180: Automatic closing On; value indicates the time in

seconds after which the door closes

Ex works the parameter 5 is set to 000, that means the automatic closing

is Off.

„P-C" Closing by motor

This parameter must always be set to 000.

Value 000: Closing by counter weight or closing spring - only valid

for fire protection doors!!!

Value 001:

Closing with motor, 24/48 VDC motors

Value 002:

Closing with motor, three-phase motors VAC

„P-d" „Release function for electric door locks"

This parameter must always be adjusted to 000. Its function, to control

a door lock, cannot be used with the E8 control system (special feature

of the E82 control system).

closing - priority of the closing command

Technical Manual E8

Page 05.023.11