Axis S2024 Руководство пользователя - Страница 11

Просмотреть онлайн или скачать pdf Руководство пользователя для Сервер Axis S2024. Axis S2024 14 страниц. Camera station s20 appliance series
Также для Axis S2024: Руководство по установке (17 страниц), Руководство пользователя (18 страниц)

Печатать страницу

AXIS Camera Station S20 Appliance Series

Network

The network page allows you to configure the IP address of the switch and to manage the built-in DHCP server controlling the

assignment of IP addresses of cameras or other devices attached to the switch's ports.

The Network screen contains two panes:

•

Switch Configuration

•

Switch DHCP Server

Switch Configuration

The switch configuration allows you to manage the IP assignment of the switch, its subnet mask, gateway, and DNS.

The factory default setting is a Static IP connection type with an address of 192.168.50.1 and a subnet mask of 255.255.255.0.

You can enter a different address through this pane, but for most camera installations we recommend you to use default settings. The

reason is that this network will normally be isolated from the corporate LAN and will only be used for managing and collecting

camera and related security application data by the video management software (VMS) residing on the server.

If an installation requires that other applications (not residing on the AXIS S20xx Server) are able to access devices on the switch, the

traffic must pass through a physical connection to the U1 port. However, in most instances this is undesirable, and not recommended,

since it would introduce traffic from cameras to the corporate LAN.

If direct access to devices on the switch from external applications is required, then you should set the Gateway, DNS 1, and DNS 2

for allowing traffic to pass from the switch to other subnets and to resolve domain names to IP addresses.

Features of this pane are:

Connection Type - The default setting is Static IP.

IP Address - The IP address of the U1 switch connection. The switch web-interface can be accessed through this address.

Subnet Mask - The subnet mask of the U1 switch connection.

Gateway - The gateway for accessing the U1 switch connection.

DNS 1 - The primary domain name server used by the switch.

DNS 2 - An alternate domain name server used by the switch.

Reset - Clears all the entries allowing you to start again.

Save - Saves the changes made in any of the network settings. For these changes to take effect, you must reboot the switch.

DHCP Server

From the Switch DHPC Server pane you can configure the switch to use its internal DHCP server for assigning IP addresses to attached

devices. You can also set the dynamic IP address lease length for renewal with a minimum setting of 60 minutes.

When using the U1 connection for allowing devices to access or being accessed by external applications the gateway and DNS

addresses must be specified.

The Intel I211 Network Interface connects the server to the built-in switch and should always be set to use DHCP.

Important

If the switch's DHCP is enabled and the server is connected to an external network via the U1 network connector, no other

DHCP hosts can be in use on the external network, otherwise there will be IP address conflicts.