EPH Controls R27-HW Инструкции по установке
Просмотреть онлайн или скачать pdf Инструкции по установке для Материнская плата EPH Controls R27-HW. EPH Controls R27-HW 2 страницы. 2 zone programmer
Также для EPH Controls R27-HW: Инструкция по эксплуатации (2 страниц), Инструкция по эксплуатации (2 страниц)
Печатать страницу
R27-HW - 2 Zone Programmer
CAUTION!
Installation and connection should only be carried out by a quali ed
person and in accordance with national wiring regulations.
Before commencing any work on the electrical connections, you must rst disconnect the programmer
from the mains. None of the 230V connections must be live until the installation has been completed
and the housing is closed. Only quali ed electricians or authorised service sta are permitted to open
the programmer. Disconnect from mains supply in the event of any damage to any buttons.
There are parts that carry mains voltage behind the cover. The programmer must not be left
unsupervised when open. (Prevent non specialists and especially children from gaining access to it.)
If the programmer is used in a way not speci ed by the manufacturer, its safety may be impaired.
Prior to setting the timeswitch, it is neccessary to complete all required settings described in this section.
Never remove this product from the electrical baseplate. Do not use sharp tools to push any button.
This programmer can be mounted in the following ways: 1. Directly wall mounted 2. Mounted to a recessed conduit box
1
160.5
3
5
EPH Controls Ireland
[email protected] www.ephcontrols.com
Type
IP20
1C
EN60730
EN60529
50
122
°C
°F
0
32
5-95%RH
Page 1 of 2
Installation Instructions
For use in normal environments.
Important: Keep this document
This 2 zone programmer is designed to provide ON/OFF
control for one hot water and one heating zone, with the
value added application of in built frost protection.
2
4
6
EPH Controls UK
[email protected] www.ephcontrols.co.uk
20180621_R27-HW_InsIns_JW