DieHard 200.71224 Руководство пользователя - Страница 14
Просмотреть онлайн или скачать pdf Руководство пользователя для Зарядное устройство DieHard 200.71224. DieHard 200.71224 17 страниц. Battery charger 15/2 amp fully automatic microprocessor controlled engine starter 100 amp
Также для DieHard 200.71224: Руководство пользователя (16 страниц)
Печатать страницу
Performance
problems often can be corrected by the user. Please read through this
chart for a possible solutions to common problems.
PROBLEM
POSSIBLE
CAUSE
SOLUTION
Indicator lights are lit in
The charger may be
Return to place of
an errat c manner not
defective,
purchase for a
] explained in the "Using
replacement.
Your Battery Charger"
section.
The red abort light always
flashes
before the battery
is charged.
Engine crank time is less
than specified.
The green full charge light
turns on a few minutes
after connecting to the
battery.
This will happen if the
battery did not reach full
charge within 24 hours.
May be due to a very large
battery or a bank of
batteries requiring more
than what a 15 Amp
charger can deliver within
24 hours. The battery may
also be bad.
Starter motor may be
drawing more than 100
Amps.
The battery may be fully
charged or recently
charged leaving the
battery voltage high
enough to make the
charger think the battery
is fully charged.
Reset the charger by
unplugging it or briefly
disconnecting
the negative
battery clip. Select the
desired charge rate and
battery type again, if
necessary,
Charge the battery at the
15 Amp rate for 10 to 15
minutes then crank the
engine.
If the battery is in a vehicle
turn the headlights on for a
few minutes to reduce the
battery voltage and try
charging again:
For information
about troubleshooting,
call toll-free
from anywhere
in the
U.S.A.
7 am to 4:30 pm CT Monday
through
Friday.
1-800-SEARS-64
(1-800-732-7764).
14