DieHard 200.71225 Руководство пользователя - Страница 9
Просмотреть онлайн или скачать pdf Руководство пользователя для Зарядное устройство DieHard 200.71225. DieHard 200.71225 17 страниц. Microprocessor controlled, fully automatic operation battery charger with engine starter plus battery and alternator tester for 6 and 12-volt batteries
Также для DieHard 200.71225: Руководство по эксплуатации (20 страниц)
Печатать страницу
isnormal forthe fan tostart a nd stop when
maintaining
afully charged battery. The fan
does notruninTester Mode.
Ifthecharge m ode i schanged after c harg-
inghas started ( by pressing theCHARGE
RATE orBATTERY TYPE button), the
charging process will b erestarted.
The voltage d isplayed
during c harging is
thecharging voltage a ndusually willbe
higher than thebattery's resting voltage.
71225 CONTROL PANEL
DISPLAY
MODE
SWITCH
Use this switch
button to set the function
of
the digital
display
to one of the following.
• BATTERY
%: The digital display
shows
an estimate
of the percent
of charge
of
the battery
connected
to the charger
battery
clamps.
• VOLTAG
E: The digital display shows the
voltage
at the charger
battery
clamps
in
DC volts.
• ALTERNATOR
%: The digital
display
shows
an estimated
percentage
of the
output
of the vehicle
charging
system
connected
to the charger
battery clamps
as compared
to a properly
functioning
system.
BATTERY
TYPE
SWITCH
Use this switch
button
to set the type of
battery
to be charged
to one of the fol-
lowing.
•
12V
REGULAR:
This
is the
type
of
battery
usually
used
in cars,
trucks,
and motorcycles.
These
batteries
have
vent
caps
and are often
marked
"low
maintenance"
or "maintenance-free".
•
12V DEEP
CYCLE:
Deep cycle batter-
ies are usually
marked
as "deep cycle"
or "marine".
Deep
cycle
batteries
are
usually
larger than the other types.
• 12VAGM/GEL:
AGM
and gel cell bat-
teries
have sealed
cases
without
vent
caps.
Such batteries
are often
smaller
than the other types.
• 6V REGULAR:
This is the type of bat-
tery usually
used
in antique-and
some
specialized
vehicles.
The 6V REGULAR
battery type is not selectable
for batteries
greater
than 8.5V DC.
With the exception
of AGM
and gel cell
batteries,
all other
battery
types
may
or
may
not have
vent
caps.
Vent caps
are
located
on top of the battery
and provide
a
means to add distilled
water when needed.
Batteries
should
be marked
with their type.
If charging
a battery
that is not marked,
check
the manual
of the item
that uses
the battery.
If the battery
type is unknown,
use the REGULAR
setting.
Make sure the
battery complies
with the safety instructions
on page 3.
CHARGE
RATE SWITCH
Use this switch
button to set the maximum
charge
rate to one of the following.
2ASLOW
CHARGE
RATE:
Intended
for
charging
small
batteries
such as those
commonly
used in garden tractors,
snow
mobiles
and motorcycles.
The 2A rate
is not intended
to be used
as a trickle
charger
for larger
batteries.
• 12A
FAST
or 30A
RAPID
CHARGE
RATE:
Use
for
charging
automotive
batteries,
marine
batteries,
and
deep
cycle batteries.
Not intended for industrial
applications.
• 80ASTART:
Provides8Oampsforcrank-
ing an engine
with a weak
or run down
battery.
Always
use in combination
with
a battery.
NOTE:
To turn OFF the charger,
unplug
from the power cord from the wall outlet.