DieHard 28.71225 Руководство по эксплуатации - Страница 12
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Зарядное устройство DieHard 28.71225. DieHard 28.71225 20 страниц. 12v battery charger & engine starter
Печатать страницу
charge Rate Button
Use this button to set the maximum charge rate.
•
2A Slow charge Rate
those commonly used in garden tractors, snow mobiles and motorcycles.
•
15A fast and 40A Rapid charge Rate
marine and deep-cycle batteries. Not intended for industrial applications.
•
125A Engine Start
weak or run down battery. Always use in combination with a battery.
11.
OPERATINg INSTRUcTIONS
accordance with the assembly instructions before it is used.
The charger does not have an On/Off switch. The On and Off commands are
controlled by plugging the 71227 into a 120V AC electrical wall outlet only after
the battery connections have been made.
Thermal Runaway
The charger automatically reduces the current if it detects the battery may be
getting too hot. This is a safety precaution.
charging
1.
Ensure that all of the charger components are in place and in good working
condition, for example, the plastic boots on the battery clips.
2.
Connect the battery following the precautions listed in sections 6 and 7.
3.
Select the appropriate settings for your battery.
4.
Connect the AC power following the precautions listed in section 8.
NOTE: This charger is equipped with an auto-start feature. It will not supply
current to the battery clips until a battery is properly connected. Meaning, the
clips will not spark if touched together.
Battery connection Indicator
If the charger does not detect a properly connected battery, the CHECK (red)
LED will light. Charging will not begin if the CHECK (red) LED is on.
Automatic charging Mode
When an Automatic Charge is performed, the charger switches to the Maintain
Mode (see below) automatically after the battery is charged. For a battery with
a starting voltage under 0.1 volt, the charger will not recognize that the battery
is connected and the CHECK (red) LED will stay lit. In order to charge the
battery, use a manual charger to pre-charge the battery for five minutes to get
additional voltage into the battery.
Aborted charge
If charging cannot be completed normally, charging will abort. When charging
aborts, the charger's output is shut off, the CHECK (red) LED will blink and
the digital display will show a failure code (see the TROUBLESHOOTING
section for a description of the failure codes). In that state, the charger ignores
all buttons. To reset after an aborted charge, either disconnect the battery or
unplug the charger.
– Intended for charging small batteries such as
– Provides 125 amps for cranking an engine with a
This battery charger must be properly assembled in
9
•
– Use for charging automotive,
•