DieHard 2871222 Руководство по эксплуатации - Страница 8
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Зарядное устройство DieHard 2871222. DieHard 2871222 13 страниц. 12v battery charger & engine starter
Также для DieHard 2871222: Руководство по эксплуатации (13 страниц)
Печатать страницу
8.3
Recommended minimum AWG size for extension cord:
•
100 feet long or less - use a 14 gauge extension cord.
•
Over 100 feet long - use a 10 gauge extension cord.
9.
ASSEMBLY INSTRUCTIONS
Remove all cord wraps and uncoil the cables prior to using the battery charger.
10.
FEATURES /CONTROL PANEL
5
Setting the controls
All of the controls for your charger are located on the front of the charger. Read these
instructions to properly set the charger controls.
Ammeter
The Ammeter indicates the amount of current, measured in amps, that is being drawn
by the battery. As a battery takes on a charge, it draws less current from the charger.
Correspondingly, the meter will show less current being drawn by the battery. When the
current stops decreasing, the battery is charged.
The 2 amp charge rate may indicate some activity on the meter, although the meter
does not have the resolution to display this low rate. For the 2 amp charge rate, a
triangle has been provided. Its accuracy has been calibrated for use with small batteries.
•
Percent of Charge
The percent of charge is based on the current drawn by the battery. For this reason,
accuracy will vary with the size and battery type.
LED Indicators
•
Full Charge LED -
Maintain Mode.
Battery Type Switch
Use this switch to set the type of battery to be charged; Standard or AGM. Both settings
are for regular and deep cycle batteries. If you are not sure what type of battery you
have, select the AGM setting.
2
1.
Ammeter
2.
Battery Type Selector Switch
3.
Charge Rate Selector Switch
4.
Battery Clips
5.
Full Charge LED
Indicates the battery is fully charged and the charger is in
6
•
1
•
3
4