DieHard Portable Power 750 Руководство по эксплуатации - Страница 7
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Дистанционное пусковое устройство DieHard Portable Power 750. DieHard Portable Power 750 8 страниц. 12v dc power source and jump starter
Также для DieHard Portable Power 750: Руководство пользователя (8 страниц), Руководство по эксплуатации (7 страниц)
Печатать страницу
- 1. Table of Contents
- 2. IMPORTANT Safety INSTRUCTIONS
- 3. PRODUCT Features
- 4. Charging the INTERNAL Battery
- 5. JUMP-Starting a Vehicle Engine
- 6. Powering a 12V DC Device
- 7. DC ELECTRICAL Device Example RUN-TIME CHART
- 8. Using the Built-IN Light
- 9. Led Indicators
- 10. Storage and MAINTENANCE
- 11. 10. Specifications
- 12. 11. Accessories and Replacement Parts
8.
LED INDICATORS
To check the internal battery status, press the switch on the front of the
750 to the DISPLAY position.
The LED lights will indicate as follows:
8.1
A red light indicates a 50% or less charge and you should immediately
charge the 750.
8.2
A yellow light indicates a 50 to 75% charge. The 750 may be used, but
should be charged as soon as possible.
8.3
A green light indicates a 75% to 100% charge.
9.
STORAgE AND MAINTENANCE
IMPORTANT:
•
CHARgE IMMEDIATELY AfTER PURCHASE
•
KEEP fULLY CHARgED.
Charge the 750 internal battery immediately upon purchase, every 30
days and after every use.
All batteries are affected by temperature. The ideal storage temperature is
between 40 and 70 degrees Fahrenheit. The internal battery will gradually
self-discharge (lose power) over time more quickly in warm environments.
Leaving the battery in a discharged state may result in permanent battery
damage. To ensure satisfactory performance and avoid permanent dam-
age, charge the internal battery every month.
When the JUMP START ON/OFF switch is ON, the clamps are live and
will produce arcing or sparking if they come in contact with each other. To
prevent accidental arcing, always keep the clamps on the storage holders
and the JUMP START ON/OFF switch in the OFF position when not using
it to jump start a vehicle.
9.1
Replacing the built-in light
To replace the built-in light bulb:
1.
Turn the light off.
2.
Insert a standard (flat-blade) screwdriver into one of the two slots along
the bottom of the plastic lens and gENTLY pop the lens out. Repeat for
the other side.
3.
gently grasp the bulb and twist counter-clockwise one quarter-turn to
unscrew the bulb.
4.
Insert a replacement bulb of the same type and rating, and twist clock-
wise one quarter-turn to screw in the new bulb.
5.
Replace the lens cover.
6.
Test the light by switching the light on and off.
5
•
•