DieHard 200.71230 Руководство по эксплуатации - Страница 14
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Автомобильное зарядное устройство DieHard 200.71230. DieHard 200.71230 20 страниц. Battery charger 40/2 amp manual 200 amp engine starter
Также для DieHard 200.71230: Руководство пользователя (14 страниц), Руководство пользователя (14 страниц)
Печатать страницу
12.
OPERATING INSTRUCTIONS
12.1
SETTING ThE CONTROLS
All controls for your charger are located on the front of the unit. Follow
these instructions to obtain the accurate charge level for your battery.
12.2
Output Selector Switches:
Two switches are used to select the rate of charge or function; a 3-posi-
tion switch on the right, and a 2-position switch to the left of it. Use the
3-position switch to select:
•
2 Amp Trickle Charge:
large batteries. The lower the charge rate, the longer it will take, but the
battery is subjected to much less stress.
•
Off:
Leave the switch in the OFF Position while connecting the charger
to the battery and to the AC power outlet.
•
Select:
by the 2-position switch.
•
Use the
•
Use the
little or no charging has been done by the charger and your battery will
still need further charging by the vehicle charging system once the engine
starts.
12.3
Ammeter:
being drawn by the battery. For example, in the 40 amp charge rate, a
typical discharged battery will initially draw approximately 40 amps. As
the battery continues to charge, current will taper to 15 to 20 amps at full
charge. The Start area of the meter indicates a high rate of current be-
ing drawn from the charger. When cranking an engine, the starter motor
draws upwards to 200-300 amps. The meter needle will be at the extreme
right side of the start area. Sometimes, for the first few minutes of its
charge, the battery will draw more than 40 amps; in this case, the needle
may be within, but not all the way over, to the right side of the start area.
This setting enables you to select one of the two settings offered
40 Amp Charge rate for a fast charge.
200 Amp Engine Start for cranking the engine. Remember that
Indicates the amount of current measured in amperes that is
200A 12V
ENGINE
START
40A 12V
CHARGE
VOLT/AMP SELECTOR
Use for charging small batteries and warming
12
•
•
2A 12V
CHARGE
OFF
SELECT