AXITEC AC-290M/60S Руководство по установке - Страница 3

Просмотреть онлайн или скачать pdf Руководство по установке для Инвертор AXITEC AC-290M/60S. AXITEC AC-290M/60S 17 страниц.

1. General Safety Precautions

1.1.

Photovoltaic modules have no on/off switch. Modules can be rendered inoperative only by

removing them from sunlight, or by fully covering their front surface with cloth, cardboard,

or other completely opaque material, or by working with modules face down on a smooth,

flat surface.

1.2.

Photovoltaic modules produce DC electricity when exposed to light and therefore can

produce electrical shock or burns. Modules produce voltage even when not connected to

an electrical circuit or load. Modules produce nearly full voltage when exposed to as little

as 5% of full sunlight both current and power increase with light intensity. Use insulated

tools and rubber gloves when working with modules in sunlight. It would be best by

covering their front surface fully with completely opaque materials when operating on the

modules. Artificially concentrated sunlight shall not be directed on the module.

1.3.

Modules may produce higher output than the rated specifications. Industry standard

ratings are made at conditions of 1000 watts/m

Reflection from snow or water can increase sunlight and therefore boost current and

power. In addition, temperature below 25℃ can substantially increase voltage and power.

1.4.

Axitec LLC modules are constructed with tempered glass, but still must be handled with

care, If the front glass is broken or if the polymer back-skin is torn, contact with any module

surface or the frame can produce electrical shock, particularly when the module is wet.

Broken or damaged modules must be disposed of properly.

1.5.

Axitec LLC modules are intended for use in terrestrial applications only, thus excluding

aerospace or maritime conditions or use with sunlight concentration. Excluded applications

include, but are not limited to, installations where modules are likely to come in contact

with any salt water or where likely to become partially or wholly submerged in fresh or salt

water, we suggested that the modules should installed at least 500m away from the sea.

The mechanical and electrical installation of Module systems should be performed in accordance with all

applicable codes, including electrical codes, building codes, and electric utility interconnection

requirements. Such requirements may vary for mounting location, such as building rooftop or motor

vehicle applications.

Requirements may also vary with system voltage, and for DC or AC application. Contact local authorities

for governing regulations.

The module is considered to be in compliance with UL 1703 only when the module is mounted in the

manner specified by the mounting instructions below. Any module without a frame (laminate) shall not

be considered to comply with the requirements of UL 1703 unless the module is mounted with

Installation Manual

and 25℃ cell temperature, AM 1.5.

Page 2 / 16