Olympus BH2 Series Полная разборка, очистка и сборка - Страница 10

Просмотреть онлайн или скачать pdf Полная разборка, очистка и сборка для Микроскоп Olympus BH2 Series. Olympus BH2 Series 23 страницы. Phase contrast
Также для Olympus BH2 Series: Руководство по поиску и устранению неисправностей и настройке (46 страниц), Полная разборка, очистка и сборка (40 страниц), Разборка, очистка и сборка (45 страниц), Руководство (6 страниц), Руководство по установке (9 страниц)

Use a 2.5mm Allen wrench or driver to remove the

three M3x12 hex, socket‐head cap screws securing the

guide block to the back side of the focus block (see

Figure 13).

Figure 13 – Remove screws securing the guide block

Separate the (now loose) guide block from the focus

block (see Figure 14).

Figure 14 – Remove the guide block from the focus block

The components of the focus block assembly are shown

in Figure 15.

Figure 15 – The components of the focus block assembly

Remove the two brass shims from the guide block (see

Figure 16).

Complete Teardown, Cleaning, and Reassembly of the Olympus BH‐2 Sliding Focus Block

Figure 16 – Remove the brass shims from the focus block

Use a 2.5mm Allen wrench or driver to unscrew the two

M3x16 hex, socket‐head cap screws from the wedge

nuts, and remove the (now loose) wedge nuts (see

Figure 17).

Figure 17 – Remove screws and wedge nuts

Clean the Various Slide Components

Disassemble and clean the various components of the

sliding focus block mechanism per the following

procedure.

Remove the Guide Rails from the Arm Casting

Remove the four long guide rails from the two side

grooves in the arm casting (see Figure 18).

Figure 18 – Remove four guide rails from the arm casting

Revision 2

Page 10 of 23