Olympus BHSU Полная разборка, очистка и сборка - Страница 13

Просмотреть онлайн или скачать pdf Полная разборка, очистка и сборка для Микроскоп Olympus BHSU. Olympus BHSU 19 страниц. Reverse nosepiece

Печатать страницу

While holding the stationary base in one hand, spin the

revolving turret multiple times in both directions with

the other hand, to drive out any excess grease from

beneath the threaded retaining ring. Use dry cotton

swabs to remove any grease squeeze-out (see

32). Do not use a solvent here, otherwise the solvent

may run into the revolving turret mechanism and foul

the grease within.

Figure 32 – Remove any grease squeeze-out

Apply Grease to the Center-Pivot Bore

Apply a small amount of grease (item 8 of

into the center-pivot bore of the stationary base for the

¼" bearing ball (see

Figure

Figure 33 – Apply grease to the center-pivot bore

Reinstall the Center-Pivot Bearing Ball

Now that the center-pivot bore has been greased,

reinstall the ¼" bearing ball into the freshly greased

center-pivot bore. The grease will hold the center-pivot

bearing ball in the proper position during subsequent

reinstallation of the pivot-adjustment screw (see

34).

Complete Teardown, Cleaning, and Reassembly of the Olympus BHSU/BHTU Reverse Nosepiece Assembly

Figure

Appendix

33).

Figure

Figure 34 – Place bearing ball into the center-pivot bore

Apply Grease to Top of the Center-Pivot Ball

Apply a small amount of grease (item 8 of

onto the top of the ¼" bearing ball in the center-pivot

bore (see

Figure

Figure 35 – Apply grease to the top of the bearing ball

Reinstall the Pivot-Adjustment Screw

Use a suitable slotted screwdriver to reinstall the pivot-

adjustment screw into the threaded bore in the center

of the stationary base (see

the adjustment screw just to the point where a slight bit

of resistance is felt. Test the feel of the revolving turret.

If the motion feels rough, back the screw off a bit until it

feels smooth. Leave the screw in this position.

Figure 36 – Reinstall the pivot-adjustment screw

35).

Figure

36). Carefully snug

Revision 3

Appendix

Page 13 of 19