Olympus BHTU Полная разборка, очистка и сборка - Страница 16

Просмотреть онлайн или скачать pdf Полная разборка, очистка и сборка для Микроскоп Olympus BHTU. Olympus BHTU 19 страниц. Reverse nosepiece
Также для Olympus BHTU: Руководство по эксплуатации (22 страниц)

Печатать страницу

Figure 45 – Reinstall the knurled-rubber grip ring

Use dry cotton swabs to thoroughly remove any visible

silicone RTV squeeze-out (see

Figure 46 – Remove any silicone RTV squeeze-out

Reinstall the Wedge Mount and Corrective Optics

In order to guarantee proper optical alignment of the

turret assembly, and in order to minimize the

mechanical strain in the corrective-optics assembly for

polarizing work, reinstall the wedge mount and

corrective-optics assembly per the following procedure.

Place the wedge mount in position on the stationary

base of the turret assembly, aligning the four screw

holes in the wedge mount with the tapped holes in the

stationary base (see

Figure

Figure 47 – Place the wedge mount in position

Complete Teardown, Cleaning, and Reassembly of the Olympus BHSU/BHTU Reverse Nosepiece Assembly

Figure

46).

47).

While holding the wedge mount in this position, place

the threaded end of the corrective-optics assembly

through the center bore of the wedge mount and screw

the corrective-optics assembly into the tapped center

bore of the stationary base (see

corrective-optics assembly until it is hand tight, then

back it off approximately ¼ turn. The barrel of the

corrective-optics assembly fits the hole in the wedge

mount with very tight tolerances, and this precision fit

holds the wedge mount in the proper physical location

so that the mounting screws can be reinstalled.

Figure 48 – Reinstall the corrective-optics assembly

Use a suitable JIS screwdriver to reinstall four M2.6X25

pan-head screws to secure the wedge mount onto the

stationary base of the turret assembly (see

Figure 49 – Reinstall screws to secure the wedge mount

Use non-marring pliers or a suitable strap wrench to

grip the barrel of the corrective-optics assembly and

tighten the corrective-optics assembly a bit beyond

hand tight (see

Figure

50).

Figure

48). Tighten the

Figure

49).

Revision 3

Page 16 of 19