Olympus SZX16 Руководство по эксплуатации - Страница 23

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Микроскоп Olympus SZX16. Olympus SZX16 40 страниц. Research high-class stereo microscope
Также для Olympus SZX16: Обзор (24 страниц), Руководство по эксплуатации (36 страниц), Руководство по эксплуатации (28 страниц)

8-2 Detailed Assembly Procedure

30° or less

Downloaded from

ManualsNet.com

search engine

Installing the Pillar

Using the Allen wrench provided with the base, loosen the two

clamping screws a on the pillar support sleeve completely.

Hold the pillar b so that the Allen screwdriver storage hole comes

cap at the top, and insert the pillar into the pillar support sleeve until

it reaches the bottom.

Using the provided Allen wrench, tighten the two clamping screws

a securely.

Reserve Screw Holes

Two screw holes c (6 mm) are provided for use in mounting a

manipulator, etc.

Mounting the Focusing Assembly

First loosen the focusing assembly clamping knob a completely

and, while holding the focusing assembly with both hands, insert the

pillar c into the mounting hole b from below.

Insert slowly. Do not apply excessive force.

NOTE

Lower the focusing assembly until it stops, then tighten the focusing

assembly clamping knob a .

To prevent the microscope from turning over, the focusing

CAUTION

assembly must be installed on the same side as the

stage plate in the stand, as shown in the illustration

marked " " in figure, and its pivot angle must be limited

to 30°. If the focusing assembly is placed on the wrong

side, the microscope will turn over.

If the clamping knob a is tightened while the pillar c

NOTE

is not completely inserted into the mounting hole b , the

plate spring supporting the pillar will deform and the pillar

will not be able to penetrate into the hole.

SZX16