Olympus ENDOCAPSULE 10 SYSTEM Краткое справочное руководство

Просмотреть онлайн или скачать pdf Краткое справочное руководство для Медицинское оборудование Olympus ENDOCAPSULE 10 SYSTEM. Olympus ENDOCAPSULE 10 SYSTEM 2 страницы. Preparation and settings for capsule endoscopy
Также для Olympus ENDOCAPSULE 10 SYSTEM: Краткое руководство по эксплуатации (2 страниц)

Печатать страницу
Olympus ENDOCAPSULE 10 SYSTEM Краткое справочное руководство
ENDOCAPSULE 10 SYSTEM
This quick reference guide is only a summary of the ENDOCAPSULE instructions for use. For detailed operating instructions,
be sure to follow the ENDOCAPSULE instruction manual that was included with your device when purchased.
Before the examination
1
1. Place recorder in the cradle.
3
3. Insert antenna sheet into the
cover. Orange colored lines
printed on the surface should
face front. The cable always
stays on the patient's left side.
7
7. Insert the capsule activator into
the capsule container. The LED
should start blinking.
After the capsule ingestion
9. Press "MENU" and select
9
"Real Time View". Confirm that
images from the body are being
received properly. If necessary,
images can be played back or
captured.
After the examination
11
12
Preparation and settings for capsule endoscopy
2
4
3
4. Fasten the antenna belt
around the patient's body. The
alignment hole should fit the
umbilical area.
3
8
8. Press "MENU" and select "Real
Time View". Confirm that images
are received properly.
10
13
Note: Check that the battery is
fully charged (green light is lit).
5
5. Attach the recorder holder on
the left side of the patient's
body. Connect the recorder
and the antenna unit. Slide the
connection part until it clicks.
10. Lock the button operation. Go to "Patient
Message" and press "MENU" for at least
2 sec. When patient guidance is activated,
the patient does not necessarily need to
touch the recorder. Beep or vibration will
stop after 30 sec.
11. Unlock the recorder. Press "MENU" for more
than 2 sec. Open "Real Time View" to confirm
that the examination is complete.
12. Place recorder in the cradle.
13. A message will be displayed on the screen.
Click "OK" to start downloading image data.
When completed, a check mark will be
displayed on the main screen.
2. Log in to workstation. Register
patient information and initialize
recorder.
 Refer to the back page
6
6. Press "POWER" for at least
1 sec. Patient ID and name
are displayed on the upper left
screen.
IMPORTANT NOTICE
TO PATIENTS
When removing the capsule
from the container, be careful
NOT to touch the top cover of
the capsule. Otherwise, clear
images may not be captured.