Axkid Rekid Руководство по эксплуатации - Страница 13

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Мебель для новорожденных и детей Axkid Rekid. Axkid Rekid 16 страниц.

anchoring point needs to be as close to the floor

as possible. In doing so you you should always

insert the buckle through the closest appropri-

ate slot in the strap tp create a slip knot then

pull tight. This needs to be repeated on both

sides to create two anchor points. When install-

ing Rekid in the front passenger seat the tether

straps must be attached to the front gliding

tracks so the tether points will be located along

the front edge of the passenger seat.

Pull out the upper anchorage strap from the

belt housing (5) to an appropriate length.

Check that the white marking on the strap

(6) is visible. If not, you can try crossing the

straps over to give them some extra length

to enable the white marking to be visible.

Clip the anchor attachment directly onto the

anchorage point. Repeat on the other side.

Press down hard on the top right side of the

child restraint then repeat for the left side(7).

When you do this its important that you re-

ally use your full body weight to press down

and get the tether straps to really tighten

hard. This will give the anchorage straps their

first tightening.

Unfold the support leg out to its maximum

angle. Pull out the top latch to release the up-

per part of the support leg (8) until it reaches

the floor. If the support leg does not reach the

floor, repeat with the lower latch(9). Its impor-

tant that you check that the support leg is an

angle over 80 degress from the back of the

seat. You could check this by ensuring that

the support leg is further away from the seat

then the vertical line(10).

Press down on the child restraint from

side to side again, the anchorage straps will

be then be automatically tightened.

Continued on next page