Axler CS-HCS-60A Краткое руководство по эксплуатации - Страница 7

Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Аксессуары для фотоаппаратов Axler CS-HCS-60A. Axler CS-HCS-60A 8 страниц.

AT TA C H I N G T H E F LY W H E E L H A N D L E

The flywheel handle helps you continuously rotate the flywheel to attain

smooth camera motion along the slider. Use a 3/16" hex key to screw the

flywheel handle into the flywheel handle mount (Fig. 9).

M O U N T I N G T H E S L I D E R

Use at least two tripods or light stands to support the slider (Fig. 11). Each

end of the slider is equipped with 1/4"-20 and 3/8"-16 sockets. If your rig

is heavy and requires further support, add a third tripod to the center

mounting cheese plate, which is also equipped with 1/4"-20 and 3/8"-16

sockets (Fig. 12).

To mount the slider, follow these steps:

1. Center the camera base on the slider and lock it down by tightening

the brake.

2. Align your tripod's threaded post with the corresponding one in the

slider, and screw it in until secure. Do this for both tripods (Fig. 10).

Tip: It may be easier to turn the slider upside down to screw in your

tripods.

Note: To avoid wobbling and camera shake, use sand bags or other

weights to stabilize your tripods.

M O U N T I N G Y O U R C A M E R A T O T H E S L I D E R

Important!

Before mounting your camera, lock down the camera base by tightening

the brake.

Note: If your tripod head has a 3/8"-16 socket, use the included

3/8"-16 bushing.

1. Secure the slider on stable, level ground before mounting.

2. Tighten the brake on the camera base.

3. Rotate the tripod head clockwise until it is flush with the camera

platform and secure.

Important!

DO NOT MOUNT THE TRIPOD HEAD WITH THE CAMERA STILL ATTACHED!

Only mount the camera once the tripod head is secure on the

camera platform.

Note: If your tripod head has a 3/8"-16 socket, use the included

3/8"-16 bushing.

U S I N G T H E S L I D E R

Once your camera is mounted, loosen the brake and rotate the flywheel

to move your camera along the slider. If the slider is positioned at an

incline, keep one hand on the camera base before loosening the brake.

(Fig. 14)