Axminster AW1416VS Руководство пользователя - Страница 5

Просмотреть онлайн или скачать pdf Руководство пользователя для Токарный станок Axminster AW1416VS. Axminster AW1416VS 20 страниц. Woodturning lathe

Keep the work area as uncluttered as is practical, this includes personnel as well as

material. Under no circumstances should CHILDREN be allowed in work areas.

It is good practice to leave the machine unplugged until work is about to commence, also make sure

to unplug the machine when it is not in use, or unattended. Always disconnect by pulling on the plug

body and not the cable. Once you are ready to commence work, remove all tools used in the setting

operations (if any) and place safely out of the way. Re-connect the machine.

Carry out a final "tightness" check e.g. chuck or face plate, workpiece, tool rest, etc., check that the

correct speed has been selected.

Make sure you are comfortable before you start work, balanced, not reaching etc.

If the work you are carrying out is liable to generate flying grit, dust or chips, wear the appropriate

safety clothing, goggles, gloves, masks etc. If the work operation appears to be excessively noisy, wear

ear-defenders. If you wear your hair in a long style, wearing a cap, safety helmet, hairnet, even a

sweatband, will minimise the possibility of your hair being caught up in the rotating parts of the tool,

likewise, consideration should be given to the removal of rings and wristwatches, if these are liable to

be a 'snag' hazard. Consideration should also be given to non-slip footwear, etc.

DO NOT work with cutting tools of any description if you are tired, your attention is wandering or you

are being subjected to distraction. A deep cut, a lost fingertip or worse; is not worth it! Above all,

OBSERVE.... make sure you know what is happening around you, and USE YOUR COMMON SENSE.

1. Do not use 'split' work pieces.

2. Always start at the lowest speed when starting a new task.

3. Check that the tool rest is at or slightly below the centre line of the workpiece.

4. Check the workpiece is securely mounted in the lathe before switching on the power.

5. Rotate the workpiece by hand, to check that it is centralised, clear of the tool rest, not

'split' or has loose knots.

6. Where lathes have the facility to be reversed; check the machine is rotating in the correct

direction.

7. If your lathe has the facility to run in reverse, you must ensure that the mounting

accessories (chucks, faceplates etc.,) can be 'locked' onto the lathe mandrel, and in the case

of chucks have some form of security device to prevent them 'unwinding' during reverse

operation.

8. Make sure your tools are stored/racked away from the turning area of the lathe. Do not

reach over a rotating workpiece at any time.

9. Do not 'dig in' or try to take too large a cut.

10. Do not leave the lathe running unattended; or leave the machine until everything is

stopped.

11. Some turning tools may have specific sharpening angles that have been determined by

the manufacturers; when re-sharpening, adhere to these angles to maximise the finish of

your work.

General Instructions for 230V Machines...

A X M I N S T E R

W H I T E