Axminster ujk 106843 Руководство - Страница 20

Просмотреть онлайн или скачать pdf Руководство для Инструменты Axminster ujk 106843. Axminster ujk 106843 20 страниц. Universal dovetail jig

CORNER DOVETAIL REBATES

Fig 31-32

5) Start the cut at the right hand side of the jig moving

the router from right to left in a slow steady continuous

motion DO NOT LIFT THE ROUTER AT ANY TIME

DURING A CUT, see fig 31-32.

Opposing board - Vertical cut

1) With the comb in the same position load in & clamp

the tenon board into the jig in the vertical position

ensuring that the board is against the side stop on

the left & the board is up against the underside of the

comb, see fig 33-34. NB To support the comb leave the

horizontal board under the comb but slide it back

slightly out of the cutting area, see fig 35.

Fig 33-34-35

2) Use the wider part of the set gauge to position board

edge to the centre of the comb slot, see fig 36. NB The

cutter depth should remain the same as the previous

horizontal board cut.

3) Start the cut at the right hand side of the jig moving

the router from right to left in a slow steady continuous

motion DO NOT LIFT THE ROUTER AT ANY TIME

DURING A CUT, see fig 37.

Axminster Tool Centre Ltd, Axminster, Devon EX13 5PH

axminstertools.com/ujk

Fig 36-37

4) Try the fit, see fig 38. If more material needs to be

removed to achieve perfect corner edge alignment then

simply use the comb adjuster knobs to move the comb

towards you & recut the board - NB Ensure that both

comb adjuster knobs are moved the same amount to

ensure that the comb stays parallel to the board edge,

see 39-40.

Fig 38-39-40

Trouble shooting

Gap at one end of the joint - board not cut square, not

pushed up to the underside of the fingers, see fig 41.

Gap along the length of the joint on the inside - cutter

depth altered between cuts, board not pushed up to the

underside of the fingers, see fig 42.

Fig 41-42