Axminster D.R.O. Micro Drill Руководство пользователя - Страница 5

Просмотреть онлайн или скачать pdf Руководство пользователя для Сверло Axminster D.R.O. Micro Drill. Axminster D.R.O. Micro Drill 16 страниц.

General Instructions for 230v Machines...

Good Working Practices/Safety

The following suggestions will enable you to observe good working

practices, keep yourself and fellow workers safe and maintain your

tools and equipment in good working order.

WARNING!!

Mains Powered Tools and Machines

Primary Precautions

These machines are supplied with a molded 13 Amp Plug and 3 core power cable. Before

using the machine inspect the cable and the plug to make sure that neither are damaged. If

any damage is visible, have the damaged item inspected/repaired by a suitably qualified

person. If it is necessary to replace the plug, it is preferable to use an 'unbreakable' type

that will most resist damage. Only use a 13 Amp plug, and make sure the cable clamp is

tightened securely. Fuse as required. If extension leads are to be used, carry out the same

safety checks on them, and ensure that they are correctly rated to safely supply the current

that is required for your machine. Remember, most machines or tools have handles or

holding positions, the power cable is not one of them!

Work Place/Environment

The machine is not designed for use outside. Keep the machine clean; it will enable you to

more easily see any damage that may have occurred. Clean the machine with a damp

soapy cloth if needs be, do not use any solvents or cleaners, as these may cause damage

to any plastic parts or to the electrical components.

Keep the work area as uncluttered as is practical, this includes personnel as well as

material.

Under no circumstances should CHILDREN be allowed in work areas.

It is good practice to leave the machine unplugged until work is about to commence, also

make sure to unplug the machine when it is not in use, or unattended. To avoid inadvertent

'start up'; if your machine is not fitted with a NVR system, ensure the switch is always

returned to the OFF position. Once you are ready to commence work, remove any tools,

objects or items that could inadvertently get 'sucked up' by the machine (if any) and place

safely out of the way.

Re-connect the machine, ensuring the power cable is not 'snagged' or routed where it could

be tripped over as you move about the workshop; it is not too close to an unguarded heat

source, or is laid over or around a sharp edge.

If the work you are carrying out is liable to generate flying grit, dust or chips, wear the

appropriate safety clothing, goggles, gloves, masks etc. If the work operation appears to be

excessively noisy, wear ear-defenders.

KEEP TOOLS AND EQUIPMENT OUT

OF THE REACH OF YOUNG CHILDREN

FREEPHONE

0800 371822

A X M I N S T E R

W H I T E