AXMINSTER TOOLS WORKSHOP AW1502WSG Оригинальное руководство по эксплуатации - Страница 4
Просмотреть онлайн или скачать pdf Оригинальное руководство по эксплуатации для Шлифовальный станок AXMINSTER TOOLS WORKSHOP AW1502WSG. AXMINSTER TOOLS WORKSHOP AW1502WSG 17 страниц.
Печатать страницуGENERAL INSTRUCTIONS FOR 230V MACHINES
The following will enable you to observe good working
practices, keep yourself and fellow workers safe and
maintain your tools and equipment in good working
order.
WARNING!! KEEP TOOLS AND
EQUIPMENT OUT OF REACH
OF YOUNG CHILDREN
KEEP WORK AREA AS
UNCLUTTERED AS IS PRACTICAL
UNDER NO CIRCUMSTANCES
SHOULD CHILDREN BE ALLOWED
IN WORK AREAS.
Mains Powered Tools
• Tools are supplied with an attached 13 Amp UK 3 pin
plug, fitted with 5 amp fuse
• Inspect the cable and plug to ensure that neither are
damaged. Repair if necessary by a suitably
qualified person.
• Do not use when or where it is liable to get wet.
Workplace
• Do not use 230V a.c. powered tools anywhere
within a site area that is flooded.
• Keep machine clean.
SPECIFIC SAFETY PRECAUTIONS FOR GRINDING MACHINES
1. Do not operate your machine until it is completely
assembled and installed according to the instructions.
2. If you are not familiar with the operation of
grinding machines obtain advice from your supervisor
or instructor or another qualified person.
3. Only use grinding wheels or attachments rated
higher than 3600 rpm with a 5/8"(16mm) arbor on this
machine.
4. Never use a chipped or cracked wheel. Always
inspect each wheel before mounting it on the grinder.
If during inspection you discover a damaged grinding
wheel, replace it immediately.
5. Do not over tighten wheel nuts.
6. Always maintain a distance of 2mm or less between
• Leave machine unplugged until work is about to
commence.
• Always disconnect by pulling on the plug body
and not the cable.
•
Carry out a final check e.g. check the cutting tool
is securely tightened in the machine and the
correct speed and function set.
•
Ensure you are comfortable before you start work,
balanced, not reaching etc.
• Wear appropriate safety clothing, goggles, gloves,
masks etc. Wear ear defenders at all times.
• If you have long hair wear a hair net or helmet to
prevent it being caught up in the rotating parts of the
machine.
• Consideration should be given to the removal of rings
and wristwatches.
• Consideration should also be given to non-slip
footwear etc.
• If another person is to use the machine, ensure they
are suitably qualified to use it.
• Do not use the machine if you are tired or distracted.
• Do not use this machine within the designated safety
areas of flammable liquid stores or in areas where
there may be volatile gases.
• Check cutters are correct type and size, are
undamaged and are kept clean and sharp, this will
maintain their operating performance and lessen the
loading on the machine.
• OBSERVE.... make sure you know what is
happening around you and USE YOUR COMMON
SENSE.
the wheel and the tool rest. Adjust the tool rests as the
wheels decrease in size.
7. Ensure the tool rests are tightened so they cannot
move while in use.
8. Never grind on a cold wheel. The grinder should
always be run for at least one minute before applying
work to it.
9. Never grind on the side of the wheel. Always grind
on the face of the wheel only.
10. Never apply coolant directly to a grinding wheel,
it may cause the bonding to fail. If the work piece be-
comes hot, dip it into a water pot to cool it down.
11. Hot sparks are a hazard! Never carry out grinding
operations near flammable gas or liquid.
4