AXNER Power Arm Инструкции по сборке - Страница 2
Просмотреть онлайн или скачать pdf Инструкции по сборке для Аксессуары для электроинструментов AXNER Power Arm. AXNER Power Arm 2 страницы.
Печатать страницуAxner Power Arm: Installing a Profile Tool
Jigger Arm
w/ Handle
E
490 Kane Ct., Oviedo FL 32765 | P.O. Box 621484, Oviedo FL 32762
Clamping Bar
B
There are four adjustments when using the power jigger arm:
D
Use the upright adjusting arm to adjust the height of your jigger
4)
arm
(image
Use the Leveling Screw to adjust the angle the arm rests at
5)
(image
Loosen the wing nuts and this will allow you to slide the jigger
6)
slug in the profile tool
Slide the Jigger Slug within the Clamping Bar
7)
Watch Jolly Jiggering in action on the web!
F
800-843-7057 or 407-365-2600 | www.axner.com
Axner is a trade name of Laguna Clay Company.
Place the Clamping Bar on the Jigger
A
1)
Arm, lining it up with the holes near
the handled end. Insert a Washer and
Hex-Head Bolt into each hole
(image
C
D).
E).
(image
www.axner.com/powerarm
A).
Insert the Jigger Slug of a
2)
Profile Tool between the
Clamping Bar and Jigger Arm
to hold your profile tool in
place
(image
B).
Tighten the Hex-Head Bolts
3)
to secure your profile tool
(image
C).
F).
(image
G
Page 2 of 2
G).