ARC Audio MOTO 720 Руководство пользователя - Страница 5
Просмотреть онлайн или скачать pdf Руководство пользователя для Усилитель ARC Audio MOTO 720. ARC Audio MOTO 720 13 страниц. 4 channel motocycle and off-road amplifier
Печатать страницу
Ohm Load Matching
This ampli er is equipped with a unique impedance matching system that allows you to mix a wide range of Ohm loads
and still achieve full power. This can be done independently on the front and rear channels.
2Ω Stereo/4Ω Bridged
Any speaker or combination of speakers with a total combine Ohm load between 2 and 4 Ohms (not lower then 2 Ohms)
must use position. Bridged loads down to 4 Ohm must use this position. The ampli er will make full power at 2 Ohms
Stereo (4 Ohms bridged). Note: you can use any Ohm load above 2 Ohms in this position however power output will drop as the
impedance increases.
4Ω Stereo
Any speaker or combination of speakers with a total
combine Ohm load over 4 Ohms can use position. The
ampli er will make full power at 4 Ohms stereo (8 Ohms
bridged).
WARNING: This ampli er will not operate and could be
damaged if used in the wrong con guration. At no time
can it be operated below 2 Ohms stereo or 4 Ohms
bridged.
Speaker outputs
This ampli er is a multi channel ampli er design. Meaning it has more than one channel of speaker outputs. It is
equipped with a removable plug style terminal for speaker wire connections up to 14 AWG. Make this connection
carefully and neatly. Strip your wire back 5/16" and twist the exposed leads and insert them into the block terminal while
being careful that there is no loose or frayed strands of wire.
Tighten the standard head screw down on the terminal until
the wire is tightly secured in place. If the wires ever come in
contact with each other the ampli er will go into protection.
Know your total ohm load before you make any connec-
tions.
Strip Speaker Wire
TURN ON
5
/
16 "
8MM
CH1
POWER
PROTECT
USE 2 Ω ONLY
LOAD SWITCH MUST BE SET TO 2
CH1
POWER
PROTECT
TURN ON
4
4
CH2
CH3
4 Ω STEREO
2Ω STEREO
4 Ω BRIDGED
CH 1-2
USE 2 Ω
ONLY
LOAD
SELECT
Ω WHEN BRIDGED
CH2
CH3
4 Ω STEREO
2Ω STEREO
4 Ω BRIDGED
CH 1-2
USE 2 Ω ONLY
USE 2 Ω
LOAD
SELECT
LOAD SWITCH MUST BE SET TO 2
Ω WHEN BRIDGED
CH4
4 Ω STEREO
2Ω STEREO
4 Ω BRIDGED
CH 3-4
LOAD
SELECT
CH4
4 Ω STEREO
2Ω STEREO
4 Ω BRIDGED
CH 3-4
ONLY
LOAD
SELECT
TOP