Cino FuzzyScan F680BT Краткое руководство по эксплуатации - Страница 5
Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Считыватель штрих-кодов Cino FuzzyScan F680BT. Cino FuzzyScan F680BT 17 страниц. Cordless scanner
Также для Cino FuzzyScan F680BT: Краткое руководство по эксплуатации (17 страниц)
Печатать страницу
Use FuzzyScan in PAIR Mode
Using a suitable interface cable, connect the smart cradle to your host
device. Turn on your host device. Make sure the smart cradle is receiving
power, in which case, its LED lights will be on.
Power on the scanner and keep it well within your smart cradle's
Bluetooth range during the entire pairing process.
Please note that if the scanner is shipped together with a smart cradle,
they are pre-paired already. You will see the link indicator of scanner
gives 1 blue blink per 2.5 seconds and the central indicator of smart
cradle turns steady blue. If the scanner and smart cradle just give
alternative red and green blinks (in "Uninstall" state), please follow
step 4 to establish the connection between scanner and smart cradle.
Scan the smart cradle's Quick Pair barcode with your scanner. This will
launch the pairing process during which the scanner will emit a series of
clicking sounds, and its link indicator will flash blue rapidly. Once pairing
is completed, the scanner will beep 4 times in ascending tone, and its link
indicator will flash blue every 2.5 seconds. The smart cradle's center
indicator will be steady blue.
If the pairing process failed, you will hear the clicking sounds stop and the
link indicator of scanner will give 3 blue blinks per 2 seconds.
Thereafter, the scanner will continue to search for the smart cradle for
another 30 seconds before going into "Radio-Off" state. In the interim,
you may scan the "Uninstall" command to set the scanner to the
"Uninstall" state. If the scanner has entered radio-off state already, you
can wake it up by pressing its trigger; this will also cause the scanner to
re-attempt pairing.
Scan the corresponding host interface quick set command to complete
the installation.
The default host interface of smart cradle is preset to USB HID. If you
want to set the host interface to USB COM, you have to install the
USB virtual COM driver into your host device before using the
scanner. Please visit CINO website to download the driver.
USB
RS232
Uninstall
4