Arc Euro Trade SC3 Руководство по разборке и сборке - Страница 15

Просмотреть онлайн или скачать pdf Руководство по разборке и сборке для Токарный станок Arc Euro Trade SC3. Arc Euro Trade SC3 17 страниц.

148. Assemble onto saddle.

150. Grease / oil the feed screw and bracket.

153. Slacken the bracket screws, wind the slide right back and tighten the screws.

154. Wind the cross slide in and out. If there is any tightness, the feed screw nut will need adjusting.

160. Remove the handle again in order to fit the micrometer dial and friction spring.

149. Fit adjusting screws and adjust so slide can be moved back and forth easily by hand.

156. Put finger pressure on handle and

screw-in the adjusting screw until

you can feel it just touching the nut

and then +¼ to ½ turn extra.

157. Pinch up the cap screws equally

while winding the slide in and out

until handwheel turns freely and

with minimum drag.

Continue adjusting all three screws

until the slide moves freely along it's

full travel.

158. If required, slacken and reposition

bracket and return to adjusting the

nut.

151. Assemble onto the saddle.

161. Refit the handle assembly.

- 15 -

152. Fit the handle.

155. The centre screw is for adjusting the position

of the nut in an up/down direction and the

two outside screws are for locking. Slacken

all three screws for now.

159. Make final adjustments to the

gib screws for free movement of

the handle with little drag.