Accurate Technology DigiStop-8 Руководство по установке и эксплуатации - Страница 12

Просмотреть онлайн или скачать pdf Руководство по установке и эксплуатации для Измерительные приборы Accurate Technology DigiStop-8. Accurate Technology DigiStop-8 20 страниц. Digi-stop series

Readout Lock

To activate the Lock function Press and hold the
momentarily press the
corner of the readout. When LOCK is displayed, the +,
become inactive to prevent accidental changes of the (calibrated) current
displayed position. To de-activate the Lock function, press and hold the
key and then momentarily press the
NOTE: The Lock function can also be enabled/disabled through programming.
This allows a more permanent Lock function since programming can be
disabled with a hardware jumper inside the readout thus preventing any front
panel programming changes.
See Section 3: Readout Programming,

Readout Resolution

The Digital readout can be configured to display measurements in any of three
different resolutions.
1. Low– the resolution is
2. Normal– the resolution is:
3. High– the resolution is:
The display of fractions remains the same for all settings: 1/16, 1/32 & 1/64
See Section 3: Readout Programming,

Measurement Units

The measurement units displayed on the Readout are user configurable. The
table below provides a matrix for selecting the measurement units that may be
displayed when pressing the
See Section 3: Readout Programming,
Programming Parameter Pr 11 Value
Manual Part # 800-1070-001 Rev 10-2016
key. The word LOCK will appear in the upper left
UNITS
UNITS
key.
UNITS
0
1
2
3
4
5
6
/
ON
OFF
key.
Programming Parameter Pr3.
.1in or .1mm.
.01in or .01mm.
.001in or .01mm
Programming Parameter Pr4.
Programming Parameter Pr11
Measurement Units Displayed
All inch units, and millimeters
Millimeters only
Decimal inches and millimeters
Decimal inches and centimeters
All inch units, and centimeters
Centimeters only
Decimal inches only
key and then
and
keys
DATUM
Page 12 of 20
/
ON
OFF