Arcam Delta 60 Справочник - Страница 5

Просмотреть онлайн или скачать pdf Справочник для Усилитель Arcam Delta 60. Arcam Delta 60 12 страниц. Arcam integrated amplifier handbook
Также для Arcam Delta 60: Справочник (12 страниц), Руководство по эксплуатации (13 страниц)

Печатать страницу

Delta 60 integrated amplifier handbook

Tuner input

The tuner input is suitable for use with almost any AM or FM

tuner. Connect your tuner to the amplifier using the phono sockets

marked tuner.

Tape input/output

The Delta 60 has connections for two tape recorders and

is suitable for use with almost any cassette, reel to reel or video

tape recorder:

1 connect the 'record' leads of your tape recorder to the

phono sockets marked 'out' on the rear of the Delta 60 using phono/

phono leads

2 connect the 'playback' leads of your tape recorder to the

phono sockets marked 'in' on the rear of the Delta 60 using phono/

phono leads

Loudspeakers

The loudspeaker outputs are suitable for driving loudspeakers

in the range 4-16ohms impedance. The loudspeaker output sockets will

accept 4mm (banana) plugs. A set of 4 suitable plugs is supplied as

standard with the Delta 60. The Delta 60 has two sets of speaker outputs,

marked main and switched (SP2). The main outputs, which offer a slightly

superior sound quality to the switched, are suitable for use where

loudspeakers are to be used alone or where loudspeakers and headphones

are to be used at the same time.

The switched (SP2) outputs, in addition to the above, offer the

possibility of using headphones only. The switched (SP2) outputs are

operated by depressing the SP2 switch on the front panel of the amplifier.

When the SP2 switch is depressed the operation of the switched outputs is

identical to that of the main outputs. When the switch is out the switched

outputs are off, allowing headphones to be used alone.

The switched (SP2) outputs also give the opportunity of using

two sets of 8ohm impedance (or higher) loudspeakers with the Delta 60.

By connecting one set of speakers to the maih outputs and one to the

switched and by depressing the SP2 switch on the front of the amplifier it is

possible to drive both sets at once.

Loudspeaker connections

1 For both main and switched connections connect the

negative side (usually black) of your left hand speaker to the black terminal

of the two sockets marked 'L'. The other (the positive side or red) should be

connected to the red terminal marked 'L'.

2 Repeat for the right hand loudspeaker.

Heatsfnk/ventilation requirements

The heat produced by the amplifier is dissipated into the air

by the finned heatsink on the rear which will, along with the surrounding

panel, become warm while the amplifier is on. The whole back panel may

become quite hot if the amplifier is run near full power. This is perfectiy

normai. However, if it becomes too hot to touch, switch off the amplifier

at once and consult your dealer. It is very important that there is adequate

ventiiation for the whole of the amplifier, but especially for the rear. It is

also important to remember not to place records on top of iti