Arcam Alpha 7SE Справочник - Страница 4

Просмотреть онлайн или скачать pdf Справочник для CD-плеер Arcam Alpha 7SE. Arcam Alpha 7SE 8 страниц. Arcam cd player handbook
Также для Arcam Alpha 7SE: Справочник (8 страниц), Справочник (8 страниц)

Печатать страницу

Using your CD player - getting started

continued

REPEAT

123456789

DISPLAY

Dims or turns the display off and on. Turning the display off will

generally give a slight improvement in sound quality. Pressing

'DISPLAY' once turns the display off. To dim the display press the

'DISPLAY' button twice. To restore the display to full brightness

press 'DISPLAY' a third time.

REPEAT

To repeat the entire CD or a pre-programmed selection of tracks

press 'REPEAT' once. 'REPEAT' will illuminate on the display.

To repeat one particular track go to the track you wish to repeat

by using the ^ or H buttons (or the 0-9 keypad on the

remote control) and press 'PLAY'. Then press the REPEAT button

twice so that 'REPEAT I ' is illuminated on the display.

If you now select a different track, that one will be repeated

instead. To cancel the repeat function press 'REPEAT' a third time.

PROG

To programme a selection of up to 24 tracks from a disc in any

order To program your choice of tracks press Track

or H ,

or use the remote's 0-9 keypad orTrack H and H buttons, to

locate the desired track.

Press 'PROG'to program the track into memory (RMS is illuminated

on the display to indicate that you have begun a programmed

sequence). Repeat these steps to program all the desired tracks

into the player The display will show the track numbers that have

been programmed, the total length of the programmed sequence

and how many tracks have been programmed by use of the

number above the word 'STEP'.

If you press H or H or use the 0-9 keypad to direct dial to a

track the number above the 'STEP' will change by one and start to

flash until you press 'PROG'. After pressing 'PROG' the number

will stop flashing. If you fail to press 'PROG' within about 5

seconds the display will also stop flashing and you will have to

reselect the track you want to program.

Press 'PLAY' to start playback of the programmed tracks.

The existing program may be replayed by pressing 'PLAY'.

To clear the programmed sequence of tracks press STOP twice.

CHECK

To confirm your programmed sequence, press 'CHECK'.

The first programmed track number and track time will be

displayed. Subsequent pressing of the 'CHECK' button will display

the next track details and total time of the sequence so far.

After checking the last selection 'END' is displayed for a few

seconds. The display then reverts to showing the track details of

the last programmed track.