Arcan ALSS15 Краткое руководство по эксплуатации - Страница 2
Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Стойки и подставки Arcan ALSS15. Arcan ALSS15 4 страницы. 1,500 lb. under hoist support stand
Печатать страницу
OWNER'S MANUAL
SETUP
PLEASE REFER TO THE EXPLODED VIEW DRAWING IN THIS MANUAL IN ORDER TO IDENTIFY PARTS.
1. Screw the post support in the round base.
2. Install the extension screw in the bottom of the post until it extends out of the top of the post.
3. Place the three piece bearing assembly over the extension screw until it rests on top of the post.
4. Thread the large spin handle on the extension screw.
5. Fit the saddle on top of the extension screw and secure it to the screw by tightening the hex bolt.
6. Insert the post in the post support so the holes line up. Install the clevis pin and washer through the holes
and secure the pin on the other side with another washer and cotter pin.
OPERATING INSTRUCTIONS
This is the safety alert symbol used for the OPERATING INSTRUCTIONS section of this manual to alert you to potential personal injury
hazards. Obey all instructions to avoid possible injury or death. IMPORTANT: Before attempting to raise any vehicle, check vehicle
service manual for recommended lifting surfaces.
1. Make sure the vehicle is properly supported, stable and at the required work height before positioning the stand(s) under the vehicle
component to be supported.
2. Consult the vehicle manufacturer for the proper handling of the component and use of under hoist stands.
3. Once the stand(s) has been positioned properly under the component, hold the stand's saddle in place with one hand while turning the spin
handle in a clockwise direction with the other hand. Remove the one hand from the stand's saddle when it comes close to making contact
with the component.
4. Continue turning the stand's spin handle in a clockwise direction until it applies pressure against the component. This pressure should not
exceed what is required to support the component. Excessive pressure might cause the vehicle or its component to become unstable.
Additional precaution should be taken when using a stand equipped with a foot pedal which can raise the stand's saddle another inch more
in height and produce as much as 400 pounds of force when depressed.
5. Before removing the stand from the component, make sure the component is securely fastened to the vehicle or properly supported by
another means. Removal of the stand can be accomplished by turning the spin handle in a counterclockwise direction until the stand's
saddle is clear of the component.
PREVENTATIVE MAINTENANCE
This is the safety alert symbol used for the PREVENTATIVE MAINTENANCE section of this manual to alert you to potential personal
injury hazards. Obey all instructions to avoid possible injury or death.
1. Always store the stand in a well protected area where it will not be exposed to inclement weather, corrosive vapors, abrasive dust, or any
other harmful elements. The stand must be cleaned of water, snow, sand, grit, oil, grease or other foreign matter before using.
2. Use a general purpose grease to lubricate the extension screw and foot pedal linkage if so equipped.
3. Every stand owner is responsible for keeping the stand labels clean and readable. Use a mild soap solution to wash external surfaces of
the stand. Contact
Arcan® Professional Tools
4. Inspect the stand before each use. Do not use the stand if any component is cracked, broken or bent. Do not use the stand if it has loose
or missing hardware or components, or is modified in any way. Take corrective action before using the stand again.
ALSS15
for a replacement label if your stand's label is not readable.
2
1,500 lb. Under Hoist Support Stand
For Technical Questions, Call: 1-800-879-7316
Model ALSS15
09/06/19