Axxess AX-CH5-SWC Руководство по установке - Страница 3
Просмотреть онлайн или скачать pdf Руководство по установке для Оборудование для звукозаписи Axxess AX-CH5-SWC. Axxess AX-CH5-SWC 16 страниц. Chrysler data interface with swc2013-up
Печатать страницу
Attention! This interface will work with models that are either factory amplified, or non-amplified.
Please follow the instructions carefully for your model vehicle. Failure to do so will result in either
no sound, or low sound. If you are unsure if your vehicle is factory amplified or not, please contact
your local dealership.
For models with a factory amplifier (Fiat 500L only):
From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the Red wire to the accessory wire.
Note: If installing an AX-LCD (sold separately), there will be an accessory wire there to
connect as well.
• If the aftermarket radio has an illumination wire, connect the Orange/White wire to it.
• Connect the Blue/White wire to the amp turn on wire. This wire must be connected to hear
sound from the factory amplifier.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative output.
CONNECTIONS TO BE MADE
(CONT)
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire
• Tape off and disregard the following (1) wire, it will not be used in this application: Brown
From the AX-CH5-SWC harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Tape off and disregard the following (4) wires, they will not be used in this application:
Gray, Gray/Black, White, White/Black
• Disregard the 4-pin harness with stripped leads, it will not be used in this application.
• Connect the (2) 4-pin connectors that have Green, Green/Black, Purple, and Purple/Black wires.
• If retaining the factory backup camera, connect the Yellow RCA jack to the reverse camera input.
• If the AUX-IN jack in the dash is desired to be used, connect the Red and White RCA jacks to
the audio AUX-IN jacks of the aftermarket radio.
• The DIN jack is to be used with the optional AX-LCD (sold separately) to retain the
personalization features of the vehicle.
• Connect the Red wire to the accessory wire.
Continue to 3.5mm jack steering wheel control retention
REV. 7/18/2017 INSTAX-CH5-SWC
3