Epson 2000P - Stylus Photo Color Inkjet Printer Информация о продукте - Страница 9

Просмотреть онлайн или скачать pdf Информация о продукте для Принтер Epson 2000P - Stylus Photo Color Inkjet Printer. Epson 2000P - Stylus Photo Color Inkjet Printer 13 страниц. Product support bulletin(s)
Также для Epson 2000P - Stylus Photo Color Inkjet Printer: Руководство по настройке (17 страниц), Замена картриджей (2 страниц), Бюллетень поддержки продуктов (6 страниц), Бюллетень поддержки продуктов (1 страниц), Технические характеристики (1 страниц), Руководство пользователя (12 страниц), Бюллетень поддержки продуктов (3 страниц), Бюллетень поддержки продуктов (2 страниц), Бюллетень поддержки продуктов (4 страниц), Бюллетень поддержки продуктов (7 страниц), Краткое руководство по эксплуатации (2 страниц), Руководство по установке (8 страниц)

Печатать страницу

Epson 2000P - Stylus Photo Color Inkjet Printer Информация о продукте

6. Unwrap the ink cartridges, then remove only the yellow

part of the tape seal on top.

black ink

color ink

cartridge

You must remove the yellow tape from the top of the

cartridge or you will permanently damage it. Don't pull off

any other part of the label or try to remove the clear seal

underneath the cartridge.

Don't touch the green circuit board on the back of the

cartridge; you may inhibit normal operation and printing.

7. Tilt the ink cartridge forward slightly as you lower it into its

holder.

Hang the tabs at the back of the cartridge on the hooks on

the holder clamps.

tabs

hooks

Don't place the cartridge tabs under the hooks on the

holder clamp; you may damage the clamp when you

close it.

8. Press down the ink cartridge clamp until it locks in place.

(The color clamp is a bit harder to close than the black

clamp.)

don't touch the

green chips

9. If you need to replace the other ink cartridge, repeat steps 4

through 8 before continuing with step 10.

10. Press the yellow ink cartridge replacement button and close

the printer cover. The printer moves the print head and

begins charging the ink delivery system.

The Ppower light flashes, and the printer makes noise.

Charging takes about one minute. When it's finished, the

Ppower light stops flashing and stays on.

Cleaning the Print Head

If your printed image is unexpectedly light or faint, or has

missing bands of color, you may need to clean the print head.

This unclogs the nozzles so they can deliver ink properly.

Cleaning the print head uses ink, so clean it only if print

quality declines. You can clean the print head in either of the

following ways:

using the Head Cleaning utility (when the printer is

connected to a local port, not over a network), as described

below

using the printer's control panel buttons, as described on

page 10

6/00

EPSON Stylus Photo 2000P

Never turn off the printer while the Ppower light is

flashing, unless the printer hasn't moved or made noise

for more than 5 minutes.

When you don't turn on your printer for a long time, the

print quality can decline. It's a good idea to turn on your

printer at least once a month to maintain good print

quality.

EPSON Stylus Photo 2000P

- 9