Axxess AXAC-FD1 Руководство по установке - Страница 6

Просмотреть онлайн или скачать pdf Руководство по установке для Оборудование для звукозаписи Axxess AXAC-FD1. Axxess AXAC-FD1 8 страниц. Ford camera interface with pre-wired harness 2011-up

Печатать страницу

INSTALLATION

With the ignition cycled off:

1. Remove the harness from the factory radio display, then install the AXAC-FD1 vehicle harness

in between.

2. Connect the AXAC-FD1 vehicle harness to the AXAC-FD1 interface harness.

3. Connect the AXAC-FD1 interface harness to the AXAC-FD1 interface.

4. Make sure the camera(s) is connected to the appropriate input.

5. Make sure the interface has been configured beforehand as shown in the Configuration

section. Failure to configure the interface will result in the interface not functioning properly.

AUX-IN

PROGRAMMING

1. Cycle the ignition on and wait until the LED in the interface comes on.

Note: If the LED doesn't come on within a few seconds, yet blinks instead, turn the key to the

off position, disconnect the interface, check all connections, reconnect the interface, and then

try again.

2. Test all functions of the installation for proper operation.