Axxess AX-LR902 Руководство по установке - Страница 2
Просмотреть онлайн или скачать pdf Руководство по установке для Автомобильная электроника Axxess AX-LR902. Axxess AX-LR902 8 страниц. Land rover range rover evoque data interface with swc & factory display retention2014
Печатать страницу
From the aftermarket radio to the AX-LR902 harness:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the accessory wire.
• If the aftermarket radio has an illumination wire, connect the Orange wire to it.
• Connect the Brown wire to the mute wire.
• Connect the White wire to the left front positive speaker.
• Connect the White/Black wire to the left front negative speaker.
• Connect the Gray wire to the right front positive speaker.
• Connect the Gray/Black wire to the right front negative speaker.
• Connect the Green wire to the radio's left rear positive speaker.
• Connect the Green/Black wire to the radio's left rear negative speaker.
• Connect the Purple wire to the radio's right rear positive speaker.
• Connect the Purple/Black wire to the radio's right rear negative speaker.
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Connect the Light Green wire to the parking brake wire.
• The 6-pin harness labeled "To Parking Switch Optional" will connect to the parking brake
switch harness from the 95-9403B dash kit (sold separately).
2
CONNECTIONS TO BE MADE
From the aftermarket radio to the ASWC-1 harness:
This harness is only to be used if the vehicle is equipped with steering wheel controls or a backup camera
• Connect the Red wire to the accessory wire.
• For the radios listed below, connect the female 3.5mm connector with stripped leads, to the
male 3.5mm SWC jack from the ASWC-1 harness. Any remaining wires tape off and disregard:
• Eclipse: Connect the steering wheel control wire, normally Brown, to the Brown/
White wire of the connector. Then connect the remaining steering wheel control wire,
normally Brown/White, to the Brown wire of the connector.
• Metra OE: Connect the steering wheel control Key 1 wire (Gray) to the Brown wire.
• Kenwood or select JVC with a steering wheel control wire: Connect the Blue/Yellow
wire to the Brown wire.
• XITE: Connect the steering wheel control SWC-2 wire from the radio to the Brown wire.
• Parrot Asteroid Smart or Tablet: Connect the 3.5mm jack into the AX-SWC-PARROT (sold
separately), and then connect the 4-pin connector from the AX-SWC-PARROT into the radio.
Note: The radio must be updated to rev. 2.1.4 or higher software.
• Universal "2 or 3 wire" radio: Connect the steering wheel control wire, referred to
as Key-A or SWC-1, to the Brown wire of the connector. Then connect the remaining
steering wheel control wire, referred to as Key-B or SWC-2, to the Brown/White wire of
the connector. If the radio comes with a third wire for ground, disregard this wire.
Note: After the interface has been programmed to the vehicle, refer to the manual
provided with the radio for assigning the SWC buttons. Contact the radio manufacturer
for more information.
.
Continued on the next page