Axxess CHTO-013 Инструкции по установке - Страница 3

Просмотреть онлайн или скачать pdf Инструкции по установке для Автомобильные запчасти Axxess CHTO-013. Axxess CHTO-013 4 страницы. For chrysler vehicles 2004-up

Печатать страницу

• Connect the Gray wire to the right front positive speaker output of the

aftermarket radio.

• Connect the Gray/Black wire to the right front negative speaker output of the

aftermarket radio.

• Connect the Green wire to the radio's left rear positive speaker output.

• Connect the Green/Black wire to the radio's left rear negative speaker output.

• Connect the Purple wire to the radio's right rear positive speaker output.

• Connect the Purple/Black wire to the radio's right rear negative speaker output.

From the 22-pin Chrysler harness

Note: Use appropriate harness for your vehicle application as shown in

Applications, p.2.

• Connect the Yellow wire to the radio's 12-volt battery or memory wire.

• Connect the Black wire to the radio's ground wire.

• Connect the Blue/White wire to the radio's amp turn on wire if populated on

the factory side.

For non-amplified vehicles (only), make the following connections:

• Disconnect the (2) 4-pin connectors, with the Purple and Green wires in it.

• Connect the 4-pin harness with stripped leads to the 4-pin connector, with

the Purple and Green wires, coming from the Gray 22-pin connector.

CHTO-013

Connections to be made

• Connect the Green wire to the radio's left rear positive speaker output.

• Connect the Green/Black wire to the radio's left rear negative speaker output.

• Connect the Purple wire to the radio's right rear positive speaker output.

• Connect the Purple/Black wire to the radio's right rear negative

Tip: If you are unsure if your vehicle is amplified or not, note that these following

wires will only be populated in the factory harness if non-amplified.

• Connect the White wire to the left front positive speaker output of the

• Connect the White/Black wire to the left front negative speaker output of the

• Connect the Gray wire to the right front positive speaker output of the

• Connect the Gray/Black wire to the right front negative speaker output of

From the 12-way harness

• This harness is for the ASWC-1 (sold separately). Please refer to the ASWC-1

Continued on next page

speaker output.

aftermarket radio.

the aftermarket.

instructions for programming.