DigiDesign VENUE XO16 Руководство - Страница 10
Просмотреть онлайн или скачать pdf Руководство для Оборудование для звукозаписи DigiDesign VENUE XO16. DigiDesign VENUE XO16 12 страниц. Analog/digital output card for venue mix rack and venue sc48
Печатать страницу
Remove the card from its packing material. Hold the card by
6
its edges.
Connect the ribbon cable to the card socket. Make sure the
7
pins on the socket are correctly aligned with the ribbon cable
connector. The retaining clips on each side of the socket con-
nector automatically close when the cable connector is prop-
erly seated. Check to make sure the ribbon cable is connected
securely.
.
Connecting the ribbon cable to the card socket
Slide the output card into the slot, firmly pressing on both
8
ends of the card so that it fits snugly in the slot.
Installing the XO16 Card
Secure the card to the rear panel using the four screws you
9
removed earlier.
6
XO16 Analog/Digital Output Card
Completing and Confirming Installation
To complete and confirm installation:
Reconnect the power cable and any other cables to the
1
SC48.
Turn on your SC48.
2
Go to the Options page and click the Devices tab to view
3
your system hardware status. The newly installed card should
be displayed.
If the card does not appear in the graphic, check the ribbon
cable connection. Shut down your system, then disconnect
and reconnect the ribbon cable to the output card, making
sure to seat the connector properly in its card socket.
\
Detail of Devices tab indicating presence of an XO16 card
Go to the Patchbay page and click the Stage tab to verify
4
that the XO16 Card appears in the patchbay. The XO16's eight
analog outputs appear under "Analog Card D." The eight dig-
ital outputs appear under "Digital Card E."
In the standalone software, click the Devices tab on the Op-
5
tions page. You can right-click the SC48 graphic to see and
modify your SC48's input and output card configuration.
Detail of standalone software's Devices tab pop-up menu showing