DigiDesign VENUE AO16 Руководство - Страница 8

Просмотреть онлайн или скачать pdf Руководство для Звуковая карта DigiDesign VENUE AO16. DigiDesign VENUE AO16 12 страниц. Analog output card for venue mix rack and venue sc48

Печатать страницу

On the back panel of Mix Rack, locate output slot E and re-

move the card slot cover.

Mix Rack back panel

Remove the card from its packing material. Hold the card by

its edges.

Gently slide the card into the output slot.

When the card is seated in its slot, use the captive thumb-

screw to secure the card to Mix Rack's chassis in the back of

Mix Rack.

Secure the card to the front panel of Mix Rack using the cap-

tive thumbscrews you removed earlier.

AO16 Analog Output Card

Find the Hub48 Board ribbon cable that corresponds to the

output slot in which you have installed the card. The Hub48

board's five ribbon cables connect to the input and output

cards

Do not remove or re-seat the ribbon cable connections on

the Hub48 Board while the board is installed in the Mix

Rack. This may cause excessive flexing of the Hub48

Board. If necessary, disconnect the Hub48 and all Expan-

sion Card ribbon connections, and remove the entire assem-

bly from the rack prior to changing connections.

Output

slot E

Detail of back of Mix Rack, the Hub48 Board, and the ribbon cables

Mix Rack contains 5 ribbon cables that connect to the Input

and Output Cards. The top two ribbon cables connect to the

output cards installed in output slots D and E.

Connect the ribbon cable to the card socket on the A016

card. Make sure the pins on the socket are correctly aligned

with the ribbon cable connector. Secure the connection by

moving the retaining clips on each side of the socket connec-

tor inward. Check to make sure the ribbon cable is connected

securely.

A properly connected Expansion Card

Connects to card

in Output Slot E

Connects to card

in Output Slot D

Hub48 Board