AYA AFC3101WA Руководство по эксплуатации - Страница 18

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Холодильник AYA AFC3101WA. AYA AFC3101WA 20 страниц.

8. DEFROSTING

When the refrigerator working for a long time, the inner surface of the freezer will be covered

with a layer of hoarfrost. It may raise the electricity consumption and decrease the effect of

refrigeration. Then you should defrost your freezer once a month.

When defrosting, cut off the power, open the door and move frozen foods to a cool place.

Use a plastic spatula to remove the hoarfrost. Then remove the hoarfrost so unstuck and wipe

the inside of your freezer with a sweet and dry cloth.

Notes: Never use metal tools to defrost your freezer because it could damage it.

The refrigerator should be cleaned once a month. Before cleaning, the electric plug must be

removed from the power supply.

Wipe the inside and the outside of the refrigerator with a wet soft cloth.

If it's too dirty, clean with a soft cloth with neutral detergent and, then remove the moisture

with dry cloth.

If you leave the refrigerator idle for a long time, proceed as follows:

- Disconnect the refrigerator from the electric power supply.

- Remove all food.

- Clean and dry the inside as instructed in the direction given above for cleaning.

- Leave the doors open to prevent any unpleasant smells while the refrigerator is not used.

Cleaning:

When cleaning the refrigerator the electric plug must be removed from the power supply.

Use water or a non-abrasive detergent on a soft cloth and remove the moisture with a dry

soft cloth. Remember to clear the defrost drain at the back just above the glass cover.

Replacing the light bulb:

If the internal light does not work anymore, disconnect then reconnect at once the device. If

the light does not still work, verify if the light bulb is correctly screwed. If in spite of these tests,

there is no light, it is necessary to change the light bulb. Use a 220V, 10W light bulb.

Disconnect the appliance;

Open the light cover (1);

Undo the defective light bulb anticlockwise.

Screw the new light bulb clockwise.