3Com NJ220 - IntelliJack Switch Характеристики Руководство - Страница 3

Просмотреть онлайн или скачать pdf Характеристики Руководство для Переключатель 3Com NJ220 - IntelliJack Switch. 3Com NJ220 - IntelliJack Switch 14 страниц. Virtual lans and traffic prioritization
Также для 3Com NJ220 - IntelliJack Switch: Информационный лист (4 страниц)

Печатать страницу

3 C O M

N J 2 0 5 I N T E L L I J A C K

VLAN Configuration

and Setup

™

S W I T C H — V L A N S & T R A F F I C P R I O R I T I Z AT I O N

Forwarding Outbound-Traffic to the LAN

For most outbound data traffic, the PAN ports add VID tags to the Ethernet frames prior

to them reaching the LAN (uplink) port. In this case, the LAN port simply delivers the

outbound traffic to the network. Once on the network, the VID-tagged traffic can be

forwarded and segmented by any 802.1Q enabled switch port.

For broadcast, multicast, and unicast traffic, the outgoing Ethernet frames are tagged at

the LAN port. This tagged traffic is subsequently identified and forwarded by 802.1Q-

enabled upstream network switches.

For a step-by-step guide on setting up outbound traffic tags for the LAN port, please

refer to the section titled, Setting the Outgoing Tag Scheme.

Setting the Ingress and Egress Modes

Although the NJ205 IntelliJack Switch does not use VLAN tags, these tags are needed

by many other network devices—such as upstream switches or a VoIP phone connected

to a PAN port. To ensure traffic is appropriately tagged as it enters and exits, the NJ205

switch can be configured to add tags, remove tags, or leave frames unmodified.

The ingress mode uses the receiving port buffer to inspect and process inbound traffic.

The egress mode uses the transmitting port buffer to inspect and process outbound traf-

fic. The four settings are summarized in Table 2.

Table 2. Ingress and Egress Control Settings

Inbound

Outbound

Traffic

Tagged

Untagged

Tagged

Ingress Mode

Egress Mode

Setting

Frames received unmodified

Frames transmitted unmodified

Remove 802.1 tag if present

Frames transmitted unmodified

Frames received unmodified

Frames transmitted unmodified

Frames received unmodified

Add 802.1 tag to untagged frame