CREE LIGHTING 304 Series Инструкции по установке - Страница 2
Просмотреть онлайн или скачать pdf Инструкции по установке для Осветительное оборудование CREE LIGHTING 304 Series. CREE LIGHTING 304 Series 3 страницы. Recessed canopy petro box retrofit
Печатать страницу
TO INSTALL:
F1
1
2
3
4
5
(B)XCR (227 Series)
2 of 3
(B)XCP (304 Series)
RETROFIT FIXTURE INSTALLATION
STEP 1:
Open and remove lens frame assembly. Remove door
mounting hardware, lamp, reflector, ballast cover
and socket assembly. Disconnect incoming power
leads.
Note:
Existing ballast and capacitor may be left in
fixture if they do not interfere with the LED retrofit
module and if the existing luminaire is not supported
solely by the j-box. If removed, components should be
recycled according to all local, state, and/or federal
ordinances.
STEP 2:
Check the caulk between the Canopy and the existing
luminaire housing. Add caulk as needed to ensure
water tight installation.
STEP 3:
Slide corner brace brackets onto corners of housing
flanges. Use a non-metallic mallet only when
installing. Kit contains two brackets with cable
attachments and two brackets without. Secure
brackets in place with self-drilling screws (included)
at holes in brackets as show in
2.
Insert (4) Oval head mounting screws (included)
into bracket panel nuts so that screw head is slightly
below luminaire level.
STEP 4:
For (B)XCP (304 Series) Retrofit Assemblies
the retrofit pan must first be secured to the retrofit
housing. Set the retrofit housing on top of the retrofit
pan and secure the trim frame to the bottom of the
Figure 3.
luminaire as shown in
STEP 5:
Attach (2) hooks on ends of cables to hook mounts
Figure 4.
on fixture panel,
This will allow for hands
free wiring and support during mounting and fixture
Figure 5.
closure,
Figure 1
Figure
and
,
CI343X02R3_A