3Com OfficeConnect 140 Руководство пользователя - Страница 4

Просмотреть онлайн или скачать pdf Руководство пользователя для Переключатель 3Com OfficeConnect 140. 3Com OfficeConnect 140 9 страниц. 3com officeconnect 140 (3c16730) switch

Печатать страницу

Using the Rubber Feet and Stacking Clips

The four self-adhesive rubber feet prevent your switch

from sliding around on your desk. Stick the feet to the

marked areas at each corner of the underside of your

switch.

The four stacking clips are used for neatly and securely

stacking your OfficeConnect units together. You can

stack up to a maximum of four units. Small units

must be stacked above large units. To stack your units,

secure the clips on one side and then on the other.

Use the following method to secure one side:

Place your new u nit on

a flat surface. Your clips

fit in the se positions on

the side of the unit :

Position a clip over one

of these holes and

push it in until it clicks

into place. Repeat this

for the other clip

position on the same

side.

Keeping the front of

the units aligned, rest

the bottom of the

existing u nit on the

clips' spikes. Push the

clips firmly into the

existing u nit until they

click into place .

Repeat these steps to secure the other side.

To remove a clip, hold the units firmly with one hand

and hook the first finger of your other hand around the

back of the clip. Use reasonable force to pull it off.

Positioning Your OfficeConnect Switch

When installing your OfficeConnect switch, ensure:

It is out of direct sunlight and away from sources of heat.

Cabling is away from power lines, fluorescent lighting

fixtures, and sources of electrical noise such as radios,

transmitters and broadband amplifiers.

Water or moisture cannot enter the case of the unit.

Air flow around the unit and through the vents in the

side of the case is not restricted. We recommend you

provide a minimum of 25.4 mm (1 in) clearance.

Wall mounting the OfficeConnect Switch

There are two slots on the underside of the

OfficeConnect switch which are used for wall mounting.

You can mount the unit with the LEDs facing upwards or

downwards, to suit your needs.

When wall mounting the u nit , ensure that it is within

reach of the power outlet.

You need two suitable screws. Ensure that the wall you

are going to use is smooth, flat, dry and sturdy. Make

two screw holes which are 142 mm (5.6 in) apart. Use

the guide at the top of this page to mark the position of

the holes. Fix the screws into the wall, leaving their

heads 3 mm (0.12 in) clear of the wall surface.

Remove any connections to the unit and locate it over

the screw heads. When in line, gently push the unit on

to the wall and move it downwards to secure. When

making connections, be careful not to push the unit up

and off the wall.

CAUTION: Only wall mount single unit s, do not wall

mount stacked unit s.

Connecting Workstations and Other

Equipment to Your Switch

WARNING: Ensure you have read the Important Safety

Information section carefully before you start.

ACHTUNG: Versichern Sie sich, daß Sie den Abschnitt mit

den wichtigen Sicherheitshinweisen gelesen haben, bevor

Sie das Gerät benutzen.

AVERTISSEMENT: Assurer que vous avez lu

soigneusement la section de L'information de Sécurité

Importante avant que vous commenciez.

CAUTION: Do not power the switch off and on quickly.

Wait about 5 seconds between power cycles.