CREE LIGHTING KBL Руководство по установке - Страница 2

Просмотреть онлайн или скачать pdf Руководство по установке для Фонарь CREE LIGHTING KBL. CREE LIGHTING KBL 6 страниц. Led, universal hook and cord or pendant mount

Печатать страницу

Adjustment Screws

Pendant Slider

Plate

3/4" (19mm) IP,

1.125" (29mm)

O.D. Knockouts

"L" Channel

Loosen

Screws

2 of 6

Pendant Mount Hole

3/4" (19mm) IP, 1.125"

(29mm) O.D.

Hinged Splice

Box

1/2" (13mm) IP,

0.875" (22mm)

O.D. Knockouts

Hinged J-box

Screw

Add 2 Screws For Aluminum

Reflectors

(4) Keyhole

Slots

PENDANT MOUNT

STEP 1:

Remove hinged splice box from top of housing

by loosening screw and sliding box to the right

and up from "L" channel. Unhook from hinge

holes. See Figure 2 and 3.

STEP 2:

Remove hook, slider plate and cord and

discard. Plug junction box knockout hole with

provided junction box plug.

STEP 3:

Attach the supplied pendant mount slider plate

using (2) supplied screws (Adjustment Screws).

Use customer supplied 3/4" threaded pendant,

along with two customer supplied locknuts

(one for inside the hinged splice box and one

for outside the splice box). Pull supply leads

into position from customer supplied conduit.

Note: If necessary, the luminaire may be

balanced by loosening (2) screws for pendant

adjustment on the top of the hinged splice box

and sliding the adjustment plate as necessary

for correct balance. Tighten (2) screws when

finished. See Figure 2.

STEP 4:

Attach one end of the hinged splice box to

luminaire by aligning hinge slots on Mounting

Bracket with hinges (on splice box), and then

inserting the hinges into the slots.

STEP 5:

Make wire connections per Electrical

Connections and then push the leads into

hinged splice box. Close the hinged J-box and

re-tighten the screw. See Figure 3.

STEP 6:

Secure other end of the hinged splice box

to luminaire by sliding screw on Mounting

Bracket up and over in "L" channel on the

hinged splice box. See Figure 2.

STEP 7:

(4)

Luminaire

Secure luminaire to hinged splice box by

Mounting

tightening screw.

Tabs

STEP 8:

Locking

For luminaires with a sensor go to pages 4-6

Feature

for installation of sensor.

REFLECTOR INSTALLATION

TOOL LESS REFLECTOR:

STEP 1:

Place the reflector over the luminaire

mounting tabs so that the big reflector keyhole

slots align with the tabs. See Figure 4.

NOTE: For aluminum reflectors, insert

two screws, provided with the reflector, for

retention as shown in Figure 4.

STEP 2:

Turn the reflector counter-clockwise until it

locks into place with the locking feature. See

Figure 4.

STEP 3:

To remove the reflector, depress locking tab

and turn reflector clockwise.

LPN00513X0001A4_D