Creek Audio EVOLUTION 50A Руководство по эксплуатации - Страница 7
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Усилитель Creek Audio EVOLUTION 50A. Creek Audio EVOLUTION 50A 13 страниц. Integrated amplifier
Также для Creek Audio EVOLUTION 50A: Инструкции пользователя (8 страниц), Руководство по эксплуатации (17 страниц)
Печатать страницу
The MENU button offers some set-up options to tailor the operation of the EVOLUTION
50A to your preference. Pressing this button will reveal 3 options which can be highlighted
using the left-hand rotary control. Depressing the rotary control will select the highlighted
option to reveal further options. The options tree looks as follows:
Display Settings -
Always On
Auto Off
Display Brightness -
Full
Medium
Low
Headphone Switch -
Disable Speakers
Simultaneous Use
Configure the product to your taste by selecting the desired options with a press of the left-
hand rotary control. Use the MENU key to exit.
The BAL (Balance) button allows adjustment of the relative levels of left and right chan-
nels. This is used to compensate for non-ideal loudspeaker placement or to isolate one
channel of the audio signal. Once the BAL button has been pressed the right-hand rotary
control adjusts the balance and the relative level difference is expressed on the display. To
reset the balance to Centre, simply press the rotary control inwards. The characteristic of
the control has been tailored to maintain the same perceived volume level from the system
so as to allow easy adjustment.
The TONE button allows relative Bass and Treble levels to be adjusted if required. To
maintain optimum sound quality, the tone control circuits are normally bypassed. To activate
them, simply press and hold the TONE button until the display indicates "Tone On". Press-
ing the TONE button now cycles through Bass, Treble and Volume options. Adjustment of
the tone is done with the right-hand rotary control and pressing the control will reset the
value to zero. To disable the tone circuits again, simply press and hold the TONE button
until the screen indicates "Tone Off". Tone settings are remembered even when the con-
trols are bypassed allowing comparison of adjusted and "flat" settings.
Page: 6
The OLED display will be lit at all times the product is operating
The OLED display will go out after a short delay
Maximum screen brightness
Lowest screen brightness
Inserting a headphone jack will mute the loudspeaker outputs
Both loudspeakers and headphones will be active simultaneously