Crelling Harness 27 Инструкции по монтажу - Страница 2

Просмотреть онлайн или скачать pdf Инструкции по монтажу для Автомобильные аксессуары Crelling Harness 27. Crelling Harness 27 5 страниц.

Печатать страницу

NB. A fitting video can be found on our website - https://crelling.com/model-27.html

If fitting a brand new harness, remove any Rubber Bands & unfasten the two Horizontal Fixing Straps [a].

Place the back pad

[g]

back.

Feed the tail-ends of the two Horizontal Fixing straps through the Aluminium Bar Buckles

around the seat back as securely as possible.

Each tail end should then be passed through the Sliplock Slide

[d] Shoulder Straps

c/w Velcro

Comfort Sleeves

[e] Waist Belt Buckle

Unfasten the Waist Belt & position the Understrap

If the passenger is under 135cm place a Booster Seat or Cushion on top of the Understap to comply with child seat safety

legislation

(See last page for further information).

Position the Back Pad

down.

The harness is now ready for the passenger to be seated.

With the passenger sitting in the most upright position as possible, bring their arms through the shoulder straps [d].

10.

Now bring the understrap

11.

Connect the waist belt buckle

Nb. The Waist Belt can move freely through the leatherette Back Pad

12.

Adjust all straps to fit tightly yet comfortably by pulling the tail-ends of strapping through the Adjuster Buckles [i].

13.

If using the Houdini Stop Chest Strap [j], attach to Shoulder Straps underneath the Adjuster Buckles [i].

14.

Ensure that the three Comfort Pads

15.

Fasten the vehicle safety belt over the top of the Model 27 Harness.

16.

To remove the passenger from the harness - Unfasten the buckle on the waist belt at the centre-front.

Model 27 Fitting Instructions

of the harness against the front of the back rest & pass the two the Horizontal Fixing Straps around the seat

[a] Horizontal Fixing Straps

[f] Understrap

[g] Back Pad

[g]

& Body Harness on the seat so that the waist belt will be in line with the waist when the passenger sits

[f]

up between the legs and loop it back onto the waist belt over the buckle

[e]

to fasten the harness. Position the buckle centrally at waist level on the passenger.

[g]

are in position over the Adjuster Buckles

[c]

to prevent the Fixing Straps

[f]

centrally on the seat cushion

[g]

(see diagram [b])

& pull to tighten

[a]

from loosening during transit.

[c] 50mm Sliplok slide

[e].

See instruction

[i]

on the Shoulder & Under Straps.

[b] 50mm Aluminium

provided.