Digilin Colour Touch VW Руководство пользователя - Страница 7
Просмотреть онлайн или скачать pdf Руководство пользователя для Контроллер Digilin Colour Touch VW. Digilin Colour Touch VW 11 страниц. Vw dmx controller fw 1.0
Печатать страницуColour Touch VW - VW DMX Controller FW 1.0
User Manual
1.0 - 2 June 2021
Switching Drivers Off/On
To turn off the LED light fittings, simply tap the centre button for at least 1 second. This will turn off the LED
drivers and pause any running show. To turn back on simply tap the centre button again. This will bring up
the "Dim" menu and resume the current show.
Power on State
Upon applying power to the Colour Touch VW, the controller will apply a snapshot of values to the dim and
CCT. This is known as the power on state. This can be configured in the settings menu. Each setting is
described in Table 2.
To program the user defined state, a button sequence must be performed. First set the controllers desired
show. Then hold left and right buttons. While holding left right, hold up and down buttons until the light
sequence flashes. The user defined state is now saved.
(5 seconds)
Device Configuration
The Colour Touch VW device configuration can be configured via the front control panel. These
configuration options include device DMX address, device DMX repeats and the Power on state. The DMX
address can be adjusted from 1 to (512-Footprint) where footprint is the device repeats x 4ch. The device
repeats value control how many times the DMX sequence RGB repeats itself. The power on state can also
be configured. Adjusting these settings will require a reboot to properly apply them.
Enabling the settings menu
To access these configurations options a settings menu needs to be enabled. To enable the settings menu
hold left and right until all button LEDs flash. After the button LEDs flash a new menu item will be
accessible for 10mins. To navigate to the setting menu, use the left and right keys until "Set" appears. To
hide the settings menu before the 10min timeout power cycle the device.
Adjusting the DMX start address
Once the Settings menu is enabled the DMX start address can be adjusted.
1.
Navigate to "Set" using left and right arrows
2.
Tap down once to "Add"
3.
Tap Right once and a values will appear onscreen. This is the current DMX start setting.
4.
Use the up and down arrows to edit the DMX start address.
5.
To exit tap left back to "Add" sub menu.
6.
Then tap up to "set" to access main menu.
Figure 3 shows the settings menu navigation.
digilin.com.au
+617 3899 1267
S t a t e
M e n u I t e m
Power Off
"off"
Last State
"Las"
User
Defined
"man"
Sate
Table 2: Power on states
f u n c t i o n
DMX output powered off (set to level 0)
Run the last state
Run the user defined state
Page 7 of 11