Cres Cor H1381834C2K Инструкции по эксплуатации и техническому обслуживанию - Страница 2

Просмотреть онлайн или скачать pdf Инструкции по эксплуатации и техническому обслуживанию для Подогреватель продуктов Cres Cor H1381834C2K. Cres Cor H1381834C2K 5 страниц. Hot cabinets (aluminum / stainless)

Cres Cor H1381834C2K Инструкции по эксплуатации и техническому обслуживанию
Insulated
FL-2251
Hot Cabinet
Rev. 11 (5/14)
Page 2 of 5
OPERATING and MAINTENANCE INSTRUCTIONS
Models: H137UA...C & H13818...C Series Hot Cabinets (Aluminum)
H137SUA...C & H138S18...C Series Hot Cabinets (Stainless)
HOW TO INSTALL UNIT:
1. Place cabinet on level floor.
2. Place cabinet in a well ventilated area.
3. Plug cord end into proper wall outlet.

INITIAL OPERATION:

(For first-time operation only):
NOTE: A new oven needs to "burn off" manufacturing
oils and excess adhesive before its first use.
Do NOT load food into oven until this has
been done!
1. Turn the POWER switch on. The yellow light will
turn on.
2. Turn thermostat to #10.
3. Let unit operate for one hour.
4. Turn unit off and let cool.
5. Wipe inside clean with detergent and hot water.
HOW TO START UNIT:
1. Turn the POWER switch on. The yellow light will
turn on.
2. Turn the thermostat to #6½.
3. Preheat cabinet for one (1) hour.
4. Put food into cabinet.
5. Turn thermostat to desired setting and close door.
No. 8 setting = approx. 85°C / 185°F
No.6 setting = approx. 71°C / 160°F
No.4 setting = approx. 54°C / 130°F
Proper food holding temperature is 60°C / 140°F or higher.
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.cre scor.com
5925 Heisley Road • Mentor, OH 44060-1833
NOTE: The optional digital thermometer display
flashes when temperature in center of cabi-
net is below 140°F (60°C) or above 250°F
(121°C). Call the factory if you need different
settings.
TO TURN OFF UNIT:
Turn the POWER switch off. The yellow light will go out.
WARNING
RISK OF FIRE OR ELECTRIC SHOCK
DO NOT OPEN
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK)
NO USER-SERVICEABLE PARTS INSIDE
REPAIR SHOULD BE DONE BY AUTHORIZED SERVICE
PERSONNEL ONLY