Digilock DAR1-APS1 Руководство по эксплуатации - Страница 4
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Замки Digilock DAR1-APS1. Digilock DAR1-APS1 4 страницы. Rfid locks advanced security assigned use
Печатать страницу
Support
Error Condition Indicator
Locks emit feedback when an error condition exists.
10 rapid beeps:
The lock is binding which means that either door alignment or items in the locker are preventing the lock from operating. Press on the
door while operating the lock. If error condition persists, contact Digilock Support for assistance.
2 sets of three beeps:
The batteries are low. Replace the batteries.
1 beep:
The lock does not recognize the RFID Card or Key.
Does not Unlock with the RFID Card or User Key
The lock does not recognize the RFID Card or User Key. Follow Assign User Credential instructions to assign an RFID Card to the
lock. For immediate access, operate the lock with a registered Manager Bypass Key.
Does not Operate with a Manager Bypass Key
The lock does not recognize the Manager Bypass Key. Follow Register/Add Manager Bypass Key(s) instructions to register Manager
Bypass Key to the lock. For immediate access, operate with another registered Manager Bypass Key or with the Programming Key.
Does not Operate with the Programming Key
The lock does not recognize the Programming Key. Contact Digilock Support for assistance.
No Audible Feedback when
a.
The batteries may need to be replaced. For immediate access, touch and hold a registered Manager Bypass Key to the key slot
for approximately 10 seconds to provide external power and operate the lock.
b.
If error condition persists, loosen the mounting hardware and test.
c.
If error condition persists, remove the lock and assemble in your hand to test. If the door is locked or damage is visible, contact
Digilock Support.
d.
If the lock functions when assembled in your hands, reinstall and test again.
e.
If error condition persists, contact Digilock Support.
Battery Replacement
It is not necessary to remove the lock mounting hardware or remove the lock from door to change the batteries.
1
The batteries are located in
the rear unit of the lock.
PG-DAR1-AP-DEN
021314
Product Guide
RFID Locks Advanced Security
RFID Locks Advanced Security
is Pressed
`
2
Remove the screws and the
cover plate.
Assigned Use
DAR1-APS1 & DAR1-APV1
3
Pull the battery pack from the
rear housing.
Replace with four premium
alkaline AA batteries.
4
Place the battery pack back
into the rear housing and
screw cover plate in place.
Phone: 707 766 6000
www.digilock.com | [email protected]