Digilock Lockup M Руководство по эксплуатации - Страница 2

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Замки Digilock Lockup M. Digilock Lockup M 4 страницы. Keypad lock

Печатать страницу

Programming Instructions

Register/Add Manager Key(s)

Manager Key(s) can be registered to a lock after Initial Setup has been completed.
a.
Go to the lock requiring Manager Key(s).
b.
Press =` 55 `. The LED will turn on.
c.
Touch the Programming Key to the key slot until a two-tone beep is heard.
d.
Touch each Manager Key to the key slot. A two-tone beep will be heard for each Manager Key that is successfully registered.
e.
Touch the Programming Key to the key slot until a two-tone beep is heard and the LED turns off.
f.
Repeat above steps for each lock or follow Express Register Manager Key(s) instructions to register the same Manager Key(s)
to multiple locks.

For Lost or Stolen Keys

For a lost or stolen Programming Key:
A replacement Programming Key must be purchased and registered to the lock(s) to prevent the lost/stolen Programming Key from
accessing/programming a lock.
For lost or stolen Manager Key(s):
All registered Manager Keys must be erased and only the remaining Manager Keys must be registered to the lock(s) to prevent the lost/
stolen Manager Key from accessing a lock. Purchase additional Manager Key(s) from an authorized distributor.
a.
Collect all remaining Manager Key(s).
b.
Press =`55` . The LED will turn on.
c.
Touch the Programming Key to the key slot until a two-tone beep is heard.
d.
Touch the Programming Key to the key slot again until three sets of two-tone beeps are heard and the LED turns off. All previously
registered Manager Key(s) are erased from the lock.
e.
Follow Register/Add Manager Key(s) instructions to register the remaining Manager Key(s).
Set Lock Functionality
Each lock can be set for either shared or assigned use functionality. The default functionality is shared use. Press = to check
functionality. If in shared use, LED is red. If in assigned use, LED is green.
Set lock for assigned use functionality:
a.
Press =` 65 `. The LED will turn on.
b.
Touch the Programming Key to the key slot until a two tone beep is heard and the LED turns off.
c.
Follow Assign User Credential instructions to assign a User Code or User Key to operate the lock.
Set lock for shared use functionality:
a.
Press =` 56 `. The LED will turn on.
b.
Touch the Programming Key to the key slot until a two tone beep is heard and the LED fl ashes once.
Auto Unlock (for shared use functionality only)
When in shared use functionality, each lock can be programmed to auto unlock after a set number of hours. The default setting is OFF
(does not auto unlock).
To turn on Auto Unlock:
Press =` 95 ` then touch the Programming Key to the key slot until the LED turns on.
a.
b.
Set the number of hours: Press 1 - 99 `. Two sets of two-tone beeps will be heard and the LED will turn off.
For example: Press 4 ` to set the lock to auto unlock after 4 hours.
To turn off Auto Unlock:
a.
Press =` 94 `. The LED will start to fl ash.
b.
Touch the Programming Key to the key slot until a two tone beep is heard and the LED turns off.
Product Guide
Keypad Locks
M
Shared & Assigned Use Functionality