Cisco 2950 - Catalyst Switch Руководство - Страница 7

Просмотреть онлайн или скачать pdf Руководство для Переключатель Cisco 2950 - Catalyst Switch. Cisco 2950 - Catalyst Switch 19 страниц. Long-reach ethernet switches
Также для Cisco 2950 - Catalyst Switch: Руководство по решению (17 страниц), Бюллетень продукции (3 страниц), Бюллетень поддержки продуктов (5 страниц), Руководство по миграции (25 страниц), Бюллетень поддержки продуктов (6 страниц), Руководство по началу работы (29 страниц), Информационный лист (20 страниц)

Cisco - Connecting a Terminal to the Console Port on Catalyst Switches

GND

DTR

DCD

Catalyst 2926G Series Switch

The console and auxiliary (AUX) ports, located on the front panel of the Catalyst 2926G series switch,

are shown in the figure below.

Note: The AUX port is currently not supported.

Figure: Console and AUX Port Connectors

The console port, which is an EIA/TIA-232 asynchronous serial port with an RJ-45 connector, is a

full-featured DTE connection with hardware flow control.

Connect the terminal using a thin, flat RJ-45-to-RJ-45 rollover cable and an RJ-45-to-DB-9, an

RJ-45-to-D-subminiature female, or an RJ-45-to-D-subminiature male adapter (depending on the

terminal connector).

Table C-2: Catalyst 2926G Series Console Port Pinouts

Console Port

Pin (signal)

1 is looped to pin 8

2 (DTR)

3 (RxD)

4 (GND)

5 (GND)

6 (TxD)

7 (DSR)

8 is looped to pin 1

Note: An RJ-45-to-RJ-45 rollover cable and the adapters are provided in the console port accessories kit

shipped with your Catalyst 2926G series switch.

http://www.cisco.com/warp/public/473/9.html (7 of 19) [9/4/2003 12:36:03 PM]

Ground

Data Terminal Ready

Data Carrier Detect

Console Device

Connect to

n/a

DSR

TxD

GND

RxD

DTR

n/a