Cisco 3020 - Cisco Catalyst Blade Switch Руководство по установке - Страница 16

Просмотреть онлайн или скачать pdf Руководство по установке для Переключатель Cisco 3020 - Cisco Catalyst Blade Switch. Cisco 3020 - Cisco Catalyst Blade Switch 21 страница. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
Также для Cisco 3020 - Cisco Catalyst Blade Switch: Руководство по началу работы (37 страниц), Руководство по началу работы (31 страниц), Quickspecs (12 страниц), Примечание к выпуску (41 страниц), Примечание к выпуску (27 страниц), Примечание к выпуску (23 страниц), Примечание к выпуску (21 страниц)

Installing and Removing SFP Modules

Use only Cisco SFP modules on the switch module. Each SFP module has an internal serial EEPROM

that is encoded with security information. This encoding provides a way for Cisco to identify and

validate that the SFP module meets the requirements for the switch module.

•

Installing SFP Modules into SFP Module Slots

Figure 2-10

We strongly recommend that you do not install or remove fiber-optic SFP modules with cables attached

Caution

because of the potential damage to the cables, the cable connector, or the optical interfaces in the

SFP module. Disconnect all cables before removing or installing an SFP module.

Removing and installing an SFP module can shorten its useful life. Do not remove and insert

SFP modules more often than is absolutely necessary.

Figure 2-10

To insert an SFP module into the module slot, follow these steps:

Attach an ESD-preventive wrist strap to your wrist and to a bare metal surface on the enclosure.

Step 1

Find the send (TX) and receive (RX) markings that identify the top side of the SFP module.

Step 2

Note

Align the SFP module in front of the slot opening.

Step 3

Cisco Catalyst Blade Switch 3020 for HP Hardware Installation Guide

2-16

For detailed instructions on installing, removing, and cabling the SFP module, refer to your

SFP module documentation.

shows an SFP module that has a bale-clasp latch.

SFP Module with a Bale-Clasp Latch

On some SFP modules, the send and receive (TX and RX) markings might be replaced by arrows

that show the direction of the connection, either send or receive (TX or RX).

Chapter 2

Switch Installation

OL-8914-02