Cisco 3750 - Catalyst EMI Switch Руководство по началу работы - Страница 8

Просмотреть онлайн или скачать pdf Руководство по началу работы для Переключатель Cisco 3750 - Catalyst EMI Switch. Cisco 3750 - Catalyst EMI Switch 33 страницы. Catalyst 3750 series switches
Также для Cisco 3750 - Catalyst EMI Switch: Информационный лист (18 страниц), Мануалы по установке (47 страниц), Faq (10 страниц), Бюллетень продукции (5 страниц), Бюллетень поддержки продуктов (6 страниц), Обзор продукции (25 страниц), Описание (1 страниц), Информационный лист (23 страниц), Бюллетень поддержки продуктов (6 страниц), Руководство по началу работы (27 страниц), Информационный лист (23 страниц)

Печатать страницу
Cisco 3750 - Catalyst EMI Switch Руководство по началу работы

Downloading Cisco Network Assistant

Cisco Network Assistant is a software program that you download from Cisco.com and run on
your PC. It offers advanced options for configuring and monitoring multiple devices, including
switches, switch clusters, switch stacks, routers, and access points. Network Assistant is free—there is
no charge to download, install, or use it.
Follow these steps:
1. Go to this Web address: http://www.cisco.com/go/NetworkAssistant.
You must be a registered Cisco.com user, but you need no other access privileges.
2. Find the Network Assistant installer.
3. Download the Network Assistant installer, and run it. (You can run it directly from the Web if
your browser offers this choice.)
4. When you run the installer, follow the displayed instructions. In the final panel, click Finish to
complete the Network Assistant installation.
Refer to the Network Assistant online help and the getting started guide for more information.
Command-Line Interface
You can enter Cisco IOS commands and parameters through the CLI. Access the CLI either by
connecting your PC directly to the switch console port or through a Telnet session from a remote PC
or workstation.
Follow these steps:
1. Connect the supplied RJ-45-to DB-9 adapter cable to the standard 9-pin serial port on the PC.
Connect the other end of the cable to the console port on the switch.
2. Start a terminal-emulation program on the PC.
3. Configure the PC terminal emulation software for:
9600 baud
–
8 data bits
–
no parity
–
1 stop bit
–
no flow control
–
4. Use the CLI to enter commands to configure the switch. See the software configuration guide and
the command reference for more information.
8